Chrysler 1997 Stratus Convertible RHD Service Manual page 802

INTAKE CAMSHAFT INTAKE ROCKER ARM ROCKER ARMS CYLINDER (RIGHT SIDE) COVER SHAFT HEAD SEAL
9 - 66 2.5L ENGINE
REMOVAL AND INSTALLATION (Continued)
CYLINDER HEAD COVER
REMOVAL
(1) Remove air intake plenum. Refer to Group 11,
Exhaust and Intake Manifolds for procedure.
(2) Cover lower intake manifold with a suitable
cover during service.
(3) Disconnect and relocate spark plug wires.
(4) Remove cylinder head cover screws and remove
cover (Fig. 32).
INSTALLATION
NOTE: Before installation, clean cylinder head and
cover mating surfaces. Make certain the rails are
flat.
(1) Clean cylinder head and cover mating surfaces.
Install new gasket.
(2) Install cover and tighten cover bolt washer and
gasket assembly to 10 N·m (88 in. lbs.).
SPARK PLUG TUBE SEALS
The spark plug tube seals are located on the end of
each tube (Fig. 33). These seals slide onto each tube
to seal the cylinder head cover to spark plug tube. If
SPRINGCAP GASKET BREATHER HOSE VALVE STEM SEAL SPRING SEAT CAP HEAD GASKETS WASHER SPRING
SEAL
Fig. 32 Cylinder Head Components
VALVE CYLINDER HEAD BOLT
SEAL
these seals show signs of hardness and/or cracks they
should be replaced.
Fig. 33 Spark Plug Tube Seal
CYLINDER HEAD
REMOVAL
(1) Refer to Timing Belt removal outlined in this
section for disassembly, and remove camshaft sprock-
ets.
(2) Remove rocker arm assemblies. Refer to proce-
dure outline in this section.
SPRING PCV VALVE RETAINER LOCKS SEAL CAP
SEALS SPARK PLUG TUBE
O-RINGEXHAUST CYLINDER HYDRAULIC LASH CAMSHAFT EXHAUST CAMSHAFT (LEFT ADJUSTER ROCKER ARM ARM SHAFT FILLER CAP OIL THRUST GASKET ROCKER COVER SIDE) CASE HEAD
JX