Chrysler 1997 Stratus Convertible RHD Service Manual page 807

182 N·m (134 FT. BOLT TORQUE CRANKSHAFT BOLT 22 LBS.) mm OR SQUARE WASHER 1/2"
JX
REMOVAL AND INSTALLATION (Continued)
(3) Remove crankshaft center bolt (Fig. 50) and
remove crankshaft damper.
Fig. 50 Crankshaft Damper
(4) Reverse Procedure for Installation. See (Fig.
50) for crankshaft bolt torque.
TIMING BELT COVERS
REMOVAL
(1) Remove right inner slash shield. Refer to
Group 23, Body for procedure.
(2) Remove the accessory drive belts. Refer to
Group 7, Cooling System in for service procedure.
(3) Remove right engine mount. Refer to Engine
Mounts in this section for procedure.
(4) Remove crankshaft damper. Refer to Crank-
shaft Damper Removal in this section.
CRANKSHAFT SPROCKET RUBBER
BRACKET ENGINE BELT COVER FASTENERS UPPER LOWER TIMING BELT COVER FASTENERS TENERS RIGHT
NOTE: To remove engine mount bracket the lower
timing belt cover must be removed first.
(5) Remove the engine mount bracket (Fig. 51).
(6) Remove the timing belt covers (Fig. 51).
Remove covers in this order:
a. The upper left cover.
b. The lower cover.
c. The upper right cover.
NOTE: To remove right/rear timing belt cover, the
power steering pump bracket must be removed.
(7) To install reverse previous procedures.
FAS- TIMING
Fig. 51 Timing Belt Covers
2.5L ENGINE 9 - 71
UPPER LEFT COVER FASTENERS TIMING BELT