Chrysler 1997 Stratus Convertible RHD Service Manual page 270

LOWER STEERING COLUMN SHROUD LOWER SCREW LOCATIONS
8D - 24 IGNITION SYSTEM
REMOVAL AND INSTALLATION (Continued)
(4) Remove screws holding instrument panel top
cover to center of instrument panel (Fig. 56).
Fig. 56 Instrument Panel Top Cover—Center
(5) Pull instrument panel top cover up enough to
gain access to knee bolster screws (Fig. 57).
Fig. 57 Knee Bolster Attaching Points
(6) Remove lower knee bolster screws and knee
bolster.
(7) Remove screws from lower steering column
shroud (Fig. 58).
Fig. 58 Lower Steering Column Shroud Screw
Locations
SCREW TIONS LOCA-
KNEE BOLSTER SCREW TOP COVER
LOCATIONS UNDER TOP SCREWS
COVER
KEY CYLINDER LOWER SHROUD TILT LEVER
(8) Pull lower shroud to clear ignition cylinder and
key release, if equipped (Fig. 59).
Fig. 59 Remove Lower Shroud From Ignition
(9) Hold tilt wheel lever down and slide lower
shroud forward to remove it from column (Fig. 60).
Fig. 60 Lower Shroud Removal
(10) Tilt wheel to full down position and remove
upper steering column shroud.
LOWER SHROUD
Cylinder
JX