Chrysler 1997 Stratus Convertible RHD Service Manual page 366

END COVER KNEE BOLSTER
8M - 8 RESTRAINT SYSTEM
REMOVAL AND INSTALLATION (Continued)
(10) Remove the forward floor console nine attach-
ing screws and one push pin at forward driver's side.
(11) Pull the driver's under panel silencer outboard
off the distribution duct.
(12) Remove the instrument panel top cover
attaching screw on passenger side.
(a) Starting from right to the left side. Lift the
right rear edge of top cover to disengage the clips
along the rear edge. Do not use a nylon trim stick,
to avoid marring cover or panel.
(b) Lift rear edge and pull the top cover rear-
ward disengaging clips and remove cover.
(13) Remove the HVAC control attaching screws.
(14) Remove the radio. Access and remove the
three HVAC attaching screws to duct and panel.
Remove the three HVAC attaching bolts from the
cross-car beam.
(15) Close the glove box door.
SPEAKERS INSTRUMENT CLUSTER HVAC
Fig. 7 Instrument Panel Components
to plenum.
from Junction Block/BCM.
the cross car beam
bracket
rearward to remove.
nect Driver Airbag Module wire connector.
ers and remove the airbag module.
(16) Remove five screws attaching panel retainer
(17) Remove the steering column attaching bolts.
(18) Disconnect the engine and body wire harness
(19) Remove the fasteners:
• Four at the left end and three at the right end of
• Two at the steering column plenum
• One at the glove box hinge to cowl
• Two at the center support to the floor pan
(20) Lift up the instrument panel and move it
(21) After removal of the instrument panel discon-
(22) Remove the six Driver Airbag Module fasten-
GLOVE BOX LOCK TOP COVER CENTER BEZEL CUBBYBIN SCREW CYLINDER PASSENGER BAG MODULE END COVER INSTRUMENT CLUS- AIR- RADIO TER HOOD
JX