Chrysler 1997 Stratus Convertible RHD Service Manual page 1127

JX
ADJUSTMENTS (Continued)
(5) Using a suitable allen-wrench, rotate jack-
screws to achieve the proper gap between the door
glass weatherstrip retainer channel (Fig. 82).
(6) Verify that the quarter glass maintains even
contact with the outer belt weatherstrip.
(7) Install center and rear side rail weatherstrips
to side rail weatherstrip retainer channels.
(8) Cycle quarter glass between full up and full
down positions. Verify operation and re-adjust as nec-
essary.
(9) Tighten all fasteners.
(10) Verify that the top edge of the door glass is
beneath the lip of the weatherstrip with glass in the
full up position.
(11) Install quarter trim panel.
GLASS—FRONT/REAR ADJUSTMENT
(1) Remove quarter trim panel.
(2) Remove center and rear side rail weatherstrips
from side rail weatherstrip retainer channels.
(3) Loosen glass attachment bolts.
(4) Raise quarter glass and position correctly (Fig.
82).
(5) Tighten all fasteners.
(6) Install center and rear side rail weatherstrips
to side rail weatherstrip retainer channels.
(7) Cycle quarter glass between full up and full
down positions. Verify operation and re-adjust as nec-
essary.
(8) Install quarter trim panel.
QUARTER GLASS ALIGNMENT VERIFICATION
(1) Raise door glass to full up position.
(2) Cycle quarter glass between full up and full
down positions.
(3) Verify that quarter glass operates smoothly and
maintains correct alignment to convertible top and
door glass.
(4) Verify that quarter glass weatherstrip fully
contacts door glass.
(5) Verify that no scissoring of the door glass and
weatherstrip occurs.
(6) If any of the above conditions are found,
(a) Re-adjust quarter glass.
(b) Adjust the door glass as necessary to cure
the condition.
DOOR LATCH ADJUSTMENT
(1) Insert a suitable allen–wrench through elon-
gated slot in door end frame and loosen bolt 1/2 to
one full turn (Fig. 83).
(2) Cycle outside door handle twice.
(3) Tighten adjusting screw to 30 in. lbs.
(4) Verify latch operation.
ALLEN WRENCH DOOR SLOT
Fig. 83 Door Latch Adjustment
SPECIFICATIONS
BODY LUBRICATION SPECIFICATIONS
LUBRICATION REQUIREMENTS
Body mechanisms
inspected, cleaned, and lubricated, as required, to
maintain ease of operation and to provide protection
against rust and wear. When performing other
underhood services, the hood latch release mecha-
nism and safety catch should be inspected, cleaned,
and lubricated. During the winter season, external
door lock cylinders should be lubricated to assure
proper operation when exposed to water and ice.
Prior to the application of any lubricant, the parts
concerned should be wiped clean to remove dust and
grit. If necessary, a suitable solvent can be used to
clean the item to be lubricated. After lubricating a
component, any excess oil or grease should be
removed.
LUBRICANT APPLICATION
DOOR LOCK CYLINDERS
(1) Apply a small amount of lubricant directly into
the lock cylinder.
(2) Apply a small amount of lubricant to the key.
(3) Insert key into lock cylinder and cycle the
mechanism from the locked to the unlocked position.
NOTE: Do not add more lubricant.
(4) Cycle the lock cylinder mechanism several times
to allow the lubricant to flow throughout the cylinder.
(5) Wipe all lubricant from exterior of lock cylinder
and key.
ALL OTHER BODY MECHANISMS
(1) Clean component as described above.
(2) Apply specified lubricant to all pivoting and
sliding contact areas of component.
BODY 23 - 57
and linkages should be