Chrysler 1997 Stratus Convertible RHD Service Manual page 907

AUXILIARY JUMPER
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 77 Auxiliary Jumper Terminal
Fig. 78 PCM Bracket Screws
(3) Connect negative cable to auxiliary jumper ter-
minal.
CRANKSHAFT POSITION SENSOR
For removal/installation procedures refer to group
8D - Ignition System, Service Procedures.
CAMSHAFT POSITION SENSOR
For removal/installation procedures refer to group
8D - Ignition System, Service Procedures.
UPSTREAM HEATED OXYGEN SENSOR—2.0/2.4L
REMOVAL
(1) Raise and support vehicle.
(2) Disconnect electrical connector from sensor.
TERMINAL AIR CLEANER HOUSING MODULE POWERTRAIN CONTROL
LEFT STRUT TOWER
BRACKET SCREWS EXHAUST PIPE FLANGE
(3) Remove sensor using an oxygen sensor crow
foot wrench such as Snap-On tool YA8875 or equiva-
lent (Fig. 79).
INSTALLATION
(1) After removing the sensor, the exhaust mani-
fold threads must be cleaned with an 18 mm X 1.5 +
6E tap. If reusing the original sensor, coat the sensor
threads with an anti-seize compound such as Loctite
771-64 or equivalent. New sensors have compound on
the threads and do not require an additional coating.
Tighten the sensor to 28 N·m (20 ft. lbs.) torque.
(2) Connect elecrtical connector to sensor.
(3) Lower vehicle.
Fig. 79 Upstream Heated Oxygen Sensor Removal/
UPSTREAM HEATED OXYGEN SENSOR—2.5L
REMOVAL
(1) Raise and support vehicle.
(2) Disconnect electrical connector from sensor.
(3) Remove sensor using an oxygen sensor crow
foot wrench such as Snap-On tool YA8875 or equiva-
lent (Fig. 80).
INSTALLATION
(1) After removing the sensor, the exhaust mani-
fold threads must be cleaned with an 18 mm X 1.5 +
6E tap. If reusing the original sensor, coat the sensor
threads with an anti-seize compound such as Loctite
771-64 or equivalent. New sensors have compound on
the threads and do not require an additional coating.
Tighten the sensor to 28 N·m (20 ft. lbs.) torque.
(2) Connect elecrtical connector to sensor.
(3) Lower vehicle.
DOWNSTREAM HEATED OXYGEN SENSOR—2.0/
2.4L
The downstream heated oxygen sensor threads into
the exhaust pipe behind the catalytic convertor.
CROW
FUEL SYSTEM
Installation
OXYGEN SEN- UPSTREAM WRENCH FOOT SOR
14 - 53