Chrysler 1997 Stratus Convertible RHD Service Manual page 872

POSITION SEN- THROTTLE CONTROL SPEED THROTTLE CABLE BODY SOR THROTTLE POSITION SENSOR
14 - 18 FUEL SYSTEM
REMOVAL AND INSTALLATION (Continued)
(10) Unplug TPS and idle air control motor con-
nectors (Fig. 30) and (Fig. 31).
Fig. 30 Throttle Position Sensor
Fig. 31 Idle Air Control Motor
(11) Pry retainer tab back on throttle cable and
slide cable out of bracket (Fig. 32).
Fig. 32 Throttle Cable Attachment
THROTTLEBODY IDLE THROTTLE CABLE AIR CONTROL MOTOR
RELEASE TANG
FUEL
EGR BOLTS TUBE
(12) Slide Speed control cable out of bracket, if
equipped (Fig. 32).
(13) Remove EGR tube from intake plenum (Fig.
33).
Fig. 33 Tube and Right Plenum Support Bolt
(14) Remove plenum support bracket bolt located
rearward of EGR tube (Fig. 33).
(15) Remove 7 bolts holding upper intake plenum
and remove plenum.
(16) Disconnect electrical connectors from fuel
injectors.
(17) Remove 4 bolts holding fuel rail (Fig. 34).
Fig. 34 Fuel Rail Attachment
(18) Lift fuel rail off engine. There are spacers
under each fuel rail bolt (Fig. 35).
Fig. 35 Fuel Rail Spacers
RAIL
EGR TUBE SUPPORT
BOLTS
FUEL RAIL
SPACERS
BRACKET BOLT
JX