Chrysler 1997 Stratus Convertible RHD Service Manual page 909

AIR INLET RESONA- TOR
JX
REMOVAL AND INSTALLATION (Continued)
2.4L
REMOVAL
(1) Loosen screw holding resonator to throttle body
(Fig. 83).
(2) Loosen clamp holding resonator to air inlet
tube. Remove resonator.
INSTALLATION
(1) Install air inlet resonator to throttle body.
(2) Install air inlet tube to resonator.
(3) Tighten clamps to 3 .5 N·m (25 5 in. lbs.)
torque.
2.5L
REMOVAL
(1) Remove bolt holding resonator to intake mani-
fold (Fig. 84).
Fig. 84 Air Inlet Resonator
(2) Loosen clamp holding resonator to air inlet
tube. Remove resonator.
INSTALLATION
(1) Install air inlet tube to resonator.
(2) Tighten clamp to 3 .5 N·m (25 5 in. lbs.)
torque.
(3) Install bolt holding resonator to intake mani-
fold. Tighten to 5 .5 N·m (45 5 in. lbs.) torque.
AIR CLEANER
The air cleaner housing attaches to the inner
fender in front of the driver's side strut tower (Fig.
85). An ambient air duct supplies underhood air for
the engine.
RESONATOR B OLT AIR
FILTER ELEMENT REPLACEMENT
REMOVAL
cover. Lift cover off air cleaner housing (Fig. 86).
housing.
INSTALLATION
clasps in place.
AIR INLET RES- CLEANER ONATOR HOUSING COVER
Fig. 85 Air Inlet System
(1) Unfasten clasps on rear of air cleaner housing
Fig. 86 Air Cleaner Cover Clasps
(2) Remove filter element (Fig. 87).
(3) If necessary, clean the inside of the air cleaner
(1) Install new filter element.
(2) Place cover over air cleaner housing. Snap
AIR CLEANER HOUSING
CLASPS
FUEL SYSTEM 14 - 55