Chrysler 1997 Stratus Convertible RHD Service Manual page 810

SPECIAL TOOL 6847
9 - 74 2.5L ENGINE
REMOVAL AND INSTALLATION (Continued)
(8) Pull tensioner plunger pin.
(9) Rotate crankshaft 2 revolutions in a clockwise
direction ONLY and check the alignment of the tim-
ing marks (Fig. 53). Install tensioner pin into assem-
bly. The pin should slide in and out without any
resistance. If the pin does not slide freely, perform
the procedure again.
(10) Install front half of timing cover and engine
mount bracket (Fig. 51).
(11) Install right engine mount. Refer to procedure
outlined in this section.
(12) Remove jack from under engine.
(13) Install crankshaft damper and crankshaft
damper bolt and tighten to 182 N·m (134 ft. lbs.).
Refer to procedure outline in this section.
(14) Install accessory drive belts. Refer to the
Accessory Drive section located in Group 7 Cooling
System, for the procedure.
(15) Raise vehicle on hoist and install right inner
splash shield.
CAMSHAFT SPROCKETS
REMOVAL
(1) Hold camshaft sprocket with Special Tool 6847
loosen and remove bolt and washer (Fig. 59).
(2) Remove camshaft sprocket from camshaft.
Fig. 59 Camshaft Sprockets—Removaland
Installation
INSTALLATION
(1) Place camshaft sprocket on camshaft.
(2) Install bolt and washer to camshaft. Using Spe-
cial Tool 6847 hold camshaft sprocket and torque bolt
to 88 N·m (65 ft. lbs.) (Fig. 59).
SPECIAL MD-998713
CAMSHAFT OIL SEAL
(1) Apply light coat of engine oil to the camshaft
oil seal lip.
(2) Install the oil
MD998713 or 6863 camshaft oil seal installers (Fig.
60) and (Fig. 61).
Fig. 60 Right Cylinder Head—InstallingCamshaft Oil
Fig. 61 Left Cylinder Head—InstallingCamshaft Oil
TOOL SPECIAL TOOL 6863 SEAL CAMSHAFT
seal using Special
Seal
Seal
JX
Tool