Chrysler 1997 Stratus Convertible RHD Service Manual page 869

UPPER O-RING LOWER 0-RING
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 19 Fuel Pressure Regulator O-rings
FUEL PUMP INLET STRAINER
REMOVAL
(1) Remove fuel pump module. Refer to Fuel Pump
Module Removal in this section.
(2) Using a thin straight blade screwdriver, care-
fully pry back the locking tabs on fuel pump reser-
voir and remove the strainer (Fig. 20).
(3) Remove strainer O-ring from the fuel pump
reservoir body.
(4) Remove any contaminants by washing the
inside of the fuel tank.
Fig. 20 Inlet Strainer Removal
INSTALLATION
(1) Lubricate the strainer O-ring with clean motor
oil.
(2) Insert strainer O-ring into outlet of strainer so
that it sits evenly on the step inside the outlet.
(3) Push strainer onto the inlet of the fuel pump
reservoir body. Make sure the locking tabs on the
reservoir body lock over the locking tangs on the
strainer.
TABS INLET STRAINER
(4) Install fuel pump module. Refer to Fuel Pump
Module Installation in this section.
FUEL LEVEL SENSOR
REMOVAL
Remove fuel pump module. Refer to Fuel Pump
Module in this section.
(1) Depress retaining tab and remove the fuel
pump/level sensor connector from the BOTTOM of
the fuel pump module electrical connector (Fig. 21).
NOTE: The pump module harness on TOP of flange
is not serviceable or removable.
Fig. 21 Fuel Pump/Level Sensor Electrical
Connector
(2) Using Special Tool C-4334 terminal remover or
equivlant, remove terminals from level sensor con-
nector (Fig. 22).
Fig. 22 Terminal Removal Tool
FUEL SYSTEM 14 - 15