Chrysler 1997 Stratus Convertible RHD Service Manual page 1117

REAR SEAT SUPPORT LOWER ANCHOR VIEW A A TAB
SEAT BELT RETRACTOR
JX
REMOVAL AND INSTALLATION (Continued)
REAR OUTER SEAT BELT AND RETRACTOR
REMOVAL
(1) Remove rear seat cushion.
(2) Remove rear seat back.
(3) Remove quarter trim panel.
(4) Remove bolt holding seat belt anchor to floor
pan (Fig. 62).
(5) Remove bolt holding seat belt retractor to rear
seat support assembly.
(6) Separate seat belt and retractor assembly from
vehicle.
Fig. 62 Rear Outer Seat Belt And Retractor
INSTALLATION
(1) Position seat belt and retractor assembly to
rear seat support assembly.
(2) Engage hook on seat belt retractor to slot in
rear seat support assembly.
(3) Install bolt holding seat belt retractor to rear
seat support assembly.
(4) Route seat belt through channel and snap bezel
onto top of channel.
(5) Install bolt holding seat belt anchor to floor
pan.
(6) Verify that seat belt is not twisted when
engaged to seat belt buckle and that the tab on the
lower seat belt anchor is between the formations on
the floor pan (Fig. 62).
(7) Install quarter trim panel.
(8) Install rear seat back.
(9) Install rear seat cushion.
NOTE: Torque for both seat belt fasteners is 40 N·M
( 350 in. lbs.)
REAR INNER SEAT BELT ASSEMBLY
REMOVAL
(1) Remove rear seat cushion.
INNER SEAT BELT ASSEM FLOOR PAN BLY
REAR SEAT BACK
(2) Remove nuts holding seat belt assembly to
floor pan.
(3) Remove rear inner seat belt assembly (Fig. 63).
Fig. 63 Rear Inner Seat Belt Assembly
INSTALLATION
(1) Position rear inner seat belt assembly onto
studs on floor pan.
(2) Install nuts holding seat belt assembly to floor
pan.
(3) Install rear seat cushion.
NOTE: Torque specification for rear inner seat belt
assembly is 40 N·m (350 in. lbs.).
QUARTER GLASS
NOTE: No access is provided to glass fasteners
except if glass is in the full up position. If this posi-
tion can not be achieved, remove the quarter win-
dow module. Refer to quarter window module
procedure in this section.
REMOVAL
(1) Raise glass to full up position.
(2) Remove quarter trim panel.
(3) Partially lower convertible top.
(4) Remove fasteners attaching glass to lift chan-
nel of quarter window module (Fig. 64).
(5) Loosen latch plate hook nut.
(6) Separate glass from vehicle.
INSTALLATION
(1) Position glass in vehicle.
(2) Loosely install fasteners holding glass to lift
channel of quarter window module.
(3) Lower and secure convertible top.
(4) Tighten latch plate hook nut.
(5) Adjust quarter glass as necessary. Refer to
quarter glass adjustment procedure in this section.
BODY 23 - 47