Chrysler 1997 Stratus Convertible RHD Service Manual page 934

POWER STEERING PRES ABS HYDRAULIC CONTROL FLOW CONTROL VALVE FIT POWER UNIT HEAT SHIELD STEERING SUPPLY HOSE SURE HOSE FLUID TING
POWER STEERING PUMP SPLASH SHIELD
19 - 20 STEERING
REMOVAL AND INSTALLATION (Continued)
Fig. 25 Accessory Drive Splash Shield
steering pressure hose and a plug in the power
steering pump pressure fitting.
Fig. 26 Power Steering Fluid Pressure Hose
Attachment To Pump
(7) Remove hose clamp, attaching power steering
fluid supply hose to the power steering pump suction
fitting (Fig. 26). Then remove power steering fluid
supply hose from fitting. Install a cap on suction
fitting of power steering pump.
(8) Remove bolt at adjustment slot, (Fig. 27)
attaching front power steering pump mounting
bracket to cast aluminum accessory drive bracket on
engine.
(9) Remove bolt (Fig. 28) attaching the back of the
power steering pump to the cast aluminum mounting
bracket.
(10) Remove the antilock brakes hydraulic control
unit heat shield (Fig. 26) from the hydraulic control
unit mounting bracket.
(11) Remove retainer for wheel speed sensor cable
grommet (Fig. 29) from right inner fender.
POWER STEERING PRES POWER FRONT CAST ALUMINUM STEERING ING BRACKET BRAKE TUBE SURE HOSE MOUNTING BRACKET MOUNT PUMP BOLT
GROMMET RETAINER AND CABLE ROUTING BRACKET POWER STEERING PUMP WHEEL SPEED SEN- SPEED DRIVESHAFT ROUTING BRACKET SOR CABLE SENSOR HEAT SHIELD POWER
Fig. 27 Power Steering Pump Front Bracket
Attachment
Fig. 28 Power Steering Pump Attachment To Rear
Mounting Bracket
Fig. 29 Wheel Speed Sensor Cable Grommet
STEERING PUMP BOLT CAST STEERING
Retainer
KNUCKLE B OLT ALUMINUM ABSORBER SHOCK BRACKET
BOLT
JX