Chrysler 1997 Stratus Convertible RHD Service Manual page 531

JX
DESCRIPTION AND OPERATION (Continued)
CAB and the ABS system relay is used to detect a
problem. If a problem is detected, the CAB grounds
the G19 circuit and illuminates the lamp in the
instrument cluster.
Circuit G19 is also grounded through the ABS sys-
tem relay, contact side.
REAR FOG LAMP ON INDICATOR
On vehicles equipped with optional Fog Lamps, a
lamp internal to the cluster is illuminated when the
system is turned ON. The lamp is powered by the fog
lamp switch on circuit L36. Ground for the lamp is
provided on the Z1 circuit and terminates at the
instrument panel left side cowl.
For additional information on fog lamp operation
refer to section 8W-51.
LOW FUEL WARNING LAMP
When the Body Control Module (BCM) detects a
low fuel condition based on the fuel level sensor
input, it transmits a message across the CCD Bus to
the instrument cluster to illuminate the low fuel
lamp.
LOW WASHER FLUID LAMP
The low washer fluid lamp is used to alert the
operator that the washer fluid level is below a prede-
termined level. Power for the switch is supplied on
circuit G29 from the instrument cluster.
When the washer fluid level is low, the switch
CLOSES completing a path to ground through the
switch, illuminating the lamp.
HIGH BEAM INDICATOR LAMP
Operation of the high beam indicator lamp is con-
trolled by the Body Control Module (BCM). The BCM
receives a high beam ON signal from the headlamp
switch and sends a message over the CCD bus to the
instrument cluster for lamp illumination.
HELPFUL INFORMATION
• Check the 10 amp fuse located in cavity 9 of the
PDC.
• Check the 20 amp fuse located in cavity 7 of the
junction block.
• Check the 10 amp fuse located in cavity 11 of
the junction block.
• Check for a good ground at the instrument panel
left side cowl.
• For additional diagnostic test, refer to the appro-
priate group of the Service Manual or the Diagnostic
Test Procedures Manual.
8W - 40 INSTRUMENT CLUSTER 8W - 40 - 13