Chrysler 1997 Stratus Convertible RHD Service Manual page 406

8W - 01 - 8
SERVICE PROCEDURES (Continued)
(10) Connect battery and test all affected systems.
Fig. 12 Wire Repair
TERMINAL/CONNECTOR REPAIR-MOLEX
CONNECTORS
(1) Disconnect battery.
(2) Disconnect the connector from its mating half/
component.
(3) Insert the terminal releasing special tool 6742
into the terminal end of the connector (Fig. 13).
Fig. 13 Molex Connector Repair
(4) Using special tool 6742 release the locking fin-
gers on the terminal (Fig. 14).
(5) Pull on the wire to remove it from the connec-
tor.
(6) Repair or replace the connector or terminal, as
necessary.
8W - 01 GENERAL INFORMATION
CONNECTOR REPLACEMENT
(1) Disconnect battery.
(2) Disconnect the connector that is to be repaired
from its mating half/component
(3) Remove
required (Fig. 15)
(4) Position the connector locking finger away from
the terminal using the proper pick from special tool
kit 6680. Pull on the wire to remove the terminal
from the connector (Fig. 16) (Fig. 17).
(5) Reset the terminal locking tang, if it has one.
(6) Insert the removed wire in the same cavity on
the repair connector.
(7) Repeat steps four through six for each wire in
the connector, being sure that all wires are inserted
into the proper cavities. For additional connector pin-
out identification, refer to the wiring diagrams.
(8) Insert the connector locking wedge into the
repaired connector, if required.
(9) Connect connector to its mating half/compo-
nent.
Fig. 14 Using Special Tool 6742
the connector
Fig. 15 Connector Locking Wedge
JX
locking wedge, if