Chrysler 1997 Stratus Convertible RHD Service Manual page 325

MULTI-FUNCTION SWITCH COMBINATION FLASHER
JX
REMOVAL AND INSTALLATION
COMBINATION FLASHER
The flasher is mounted to the back side of the
multi-function switch. To gain access the upper steer-
ing column cover must be removed. Refer to Steering
Column Cover removal procedures below. The flasher
can be removed by pulling it forward. The flasher is
serviced separately from the multi-function switch.
The flasher is black in color for ease of identification
(Fig. 4).
Fig. 4 Combination Flasher Location
MULTI-FUNCTION SWITCH
REMOVAL
(1) Disconnect battery negative cable.
(2) Remove the upper steering column cover. Refer
to steering column cover removal procedures below.
(3) Remove multi-function switch mounting screws
(Fig. 5).
(4) Disconnect wire connectors. Lift the switch
straight up to remove.
TURN SIGNAL AND FLASHERS
INSTALLATION
For installation, reverse the above procedures. MOUNTING SCREWS
(1) Tighten multi-function switch to column retain-
ing screws to 2.3 N·m (20 in. lbs.) torque.
(2) Tighten steering column cover retaining screws
to 2 N·m (17 in. lbs.) torque.
Fig. 5 Multi-Function Switch
STEERING COLUMN COVER
REMOVAL
(1) Remove three lower cover attaching screws.
(2) Remove five knee bolster mounting screws and
remove bolster.
(3) Remove upper and lower covers.
(4) If removing the upper half only:
(a) Remove lower cover attaching screws.
(b) Loosen the lower part of instrument cluster
hood for clearness as necessary.
(c) Remove upper cover.
INSTALLATION
For installation, reverse the above procedures.
8J - 5