Junction Block/Body Control Module; Left Under Instrument Panel Silencer/ Duct; Mask/Lens - Chrysler 1997 Stratus Convertible RHD Service Manual

JX
REMOVAL AND INSTALLATION (Continued)
Fig. 16 Top Cover

JUNCTION BLOCK/BODY CONTROL MODULE

JUNCTION BLOCK
REMOVAL
The Junction Block and Body Control Module
(BCM) are attached to each other. After removal they
can be separated. Junction Block and Body Control
Module assemblies are located on the driver's side of
the vehicle (Fig. 17).
(1) Open the front driver's door and remove end
cap.
(2) Remove center bezel.
(3) Remove instrument cluster hood.
(4) Remove silencer.
(5) Remove wire harness connectors from Junction
Block.
(6) Remove Junction Block three mounting screws.
(7) Remove Junction
straight down from the mounting bayonet.
(8) Disconnect BCM wire connectors and remove
the assembly.
(9) Remove Junction Block/BCM from vehicle.
INSTALLATION
For installation, reverse the above procedures.
Ensure that the wire terminals and connectors are in
good condition and connectors are properly installed.
BODY CONTROL MODULE
REMOVAL
(1) The Junction Block/BCM removed from the
vehicle, separate the BCM from the Junction Block.
(2) Remove the two BCM attaching screws and
release the two BCM locking latches from the Junc-
tion Block.
SPEAKER
Block/BCM by pulling
JUNCTION/BCM
INSTRUMENT PANEL AND SYSTEMS
Fig. 17 Junction Block/BCM Location
(3) Disconnect BCM from the Junction Block.
INSTALLATION
For installation, reverse the above procedures.
LEFT UNDER INSTRUMENT PANEL SILENCER/
DUCT
REMOVAL
(1) Remove two lower knee bolster screws and slip
silencer off outboard attaching formation.
(2) Maneuver part off of center floor distribution
duct to remove.
INSTALLATION
For installation, reverse the above procedures.
Install prior to knee bolster.

MASK/LENS

REMOVAL
Remove mask/lens retaining screws and remove
mask/lens (Fig. 11).
INSTALLATION
For installation, reverse the above procedures.
8E - 11