Chrysler 1997 Stratus Convertible RHD Service Manual page 272

MOUNTINGBOLT
8D - 26 IGNITION SYSTEM
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Ensure the ignition switch is in the RUN posi-
tion and the actuator shaft in the lock housing is in
the RUN position.
(2) Carefully install the ignition switch. The
switch will snap over the retaining tabs (Fig. 65).
Install mounting screw (Fig. 63).
(3) Install electrical connectors to ignition switch.
(4) Install upper and lower shrouds.
(5) Install key cylinder (cylinder retaining tab will
depress only in the RUN position).
(6) Connect negative cable to battery.
Fig. 65 Ignition Switch Installation
(7) Check for proper operation of ignition switch
and key-in warning switch.
LOCK KEY CYLINDER
REMOVAL
(1) Disconnect negative
jumper terminal.
(2) Remove upper steering column shroud.
(3) Pull lower shroud down far enough to access
lock cylinder retaining tab.
(4) Place key cylinder in RUN position. Depress
retaining tab and remove key cylinder (Fig. 66).
INSTALLATION
(1) Install key in lock cylinder. Turn key to run
position (retaining tab on lock cylinder can be
depressed).
(2) The shaft at the end of the lock cylinder aligns
with the socket in the end of the housing. To align
the socket with the lock cylinder, ensure the socket is
in the Run position (Fig. 67).
(3) Align the lock cylinder with the grooves in the
housing. Slide the lock cylinder into the housing
until the tab sticks through the opening in the hous-
ing.
TARGET MAGNET
cable from auxillary
SOCKET
Fig. 66 Lock Cylinder Retaining Tab
Fig. 67 Socket in Lock Cylinder Housing
(4) Turn the key to the Off position. Remove the
key.
(5) Install steering column shrouds.
(6) Connect negative cable to auxillary battery ter-
minal on shock tower.
IGNITION INTERLOCK
Refer to Group 21, Transaxle for Shifter/Ignition
Interlock Service.
LOCK CYLINDER HOUSING
Refer to Steering Column in Group 19, Steering,
for Lock Cylinder Housing Service.
LOCK CYLINDER RETAINING LOCK CYLINDER HOUSING TAB
JX