Chrysler 1997 Stratus Convertible RHD Service Manual page 992

DRIVE PLATE LOWER ENGINE PULLEY
DRIVE PLATE
BOLT
21 - 24 TRANSAXLE
REMOVAL AND INSTALLATION (Continued)
Fig. 52 Rotate Engine Clockwise
Fig. 53 Converter Bolts
INSTALLATION
(1) For installation of transaxle, reverse the above
procedure.
NOTE: If the torque converter has been replaced,
refer to Torque Converter Clutch Break-in Proce-
dure in this section. This procedure will reset the
transmission control module break-in status. Fail-
ure to perform this procedure may cause transaxle
shutter.
(2) Check and/or adjust gear shift cable.
(3) Refill transaxle with MOPAR
(Automatic Transmission Fluid) Type 7176.
TRANSMISSION TRANSAXLE
TURN CLOCKWISE
ATF PLUS
JACK K-FRAME MOUNT STEERING RACK MOUNT
SWAY BAR
MOUNT
Fig. 54 Steering Gear and K-frame Bolts
Fig. 55 Sway Bar Mounts
Fig. 56 Transmission Jack
JX