Chrysler 1997 Stratus Convertible RHD Service Manual page 379

JX
SERVICE PROCEDURES
HORN CHIRP ENABLE/DISABLE
The scan tool (DRB) must be used to enable/disable
the Horn Chirp. Refer to the scan tool (DRB) for the
procedure.
SYNCHRONIZATION OF ROLLING CODE
The key fob transmitter code will go out of syn-
chronization if any button is press more than 250
times outside the range of the receiver which is
inside of the BCM. In other words the transmitter
will not work. To synchronize the code of a particular
key fob transmitter with the receiver, press and hold
the lock button then the deck lid button simulta-
neously for at lease five seconds. Then wait until the
doors unlock indicating that the code has been syn-
chronized. This may take as long as six minutes.
This is for a key fob transmitter that has been pre-
viously programed to this vehicle only.
REMOVAL AND INSTALLATION
DECK LID RELEASE RELAY
REMOVAL
(1) The relay is located above the brake pedal to
the right side (Fig. 2).
POWER DOOR LOCKS
(2) Grasp the relay and pull downward to discon-
nect the relay.
INSTALLATION
Align the relay pins with the connector terminals
and push the relay in to place.
JUNCTION BLOCK/BODY CONTROL MODULE
Refer to Group 8E, Instrument Panel and Systems.
ADJUSTMENTS
PROGRAMMING RKE MODULE
The scan tool (DRB) and the transmitter must be
used to program the Remote Keyless Entry Module.
Refer to the scan tool (DRB) for the procedure.
SPECIFICATIONS
TRANSMITTER CONTROL RANGE
Operation range is within 7 meters (23 ft.) of the
BCM.
8P - 7