Chrysler 1997 Stratus Convertible RHD Service Manual page 1109

CENTER SIDE RAIL WEATH FRONT SIDE RAIL WEATH QUARTER PANEL A PILLAR ERSTRIP ERSTRIP
CONVERTIBLE TOP CONVERTIBLE TOP
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 43 Front Side Rail Weatherstrip
(4) Adjust position of weatherstrip so that weath-
erstrip is butted tightly against A–pillar seal and
center side rail weatherstrip.
(5) Secure convertible top.
CENTER
REMOVAL
(1) Partially raise convertible top.
(2) Using a trim stick, special tool C–4755, sepa-
rate one end of weatherstrip from retainer channel.
(3) Separate weatherstrip from vehicle (Fig. 44).
Fig. 44 Center Side Rail Weatherstrip
INSTALLATION
(1) Position weatherstrip on vehicle.
(2) Push weatherstrip into retainer channel, align-
ing embossment on backside of weatherstrip to cor-
ner of retainer.
(3) Lower convertible top.
(4) Adjust position of weatherstrip so that weath-
erstrip is butted tightly against front and rear side
rail weatherstrips.
REAR SIDE RAIL WEATHER QUARTER PANEL STRIP
CONVERTIBLE TOP
(5) Secure convertible top.
REAR
REMOVAL
(1) Partially raise convertible top.
(2) Using a trim stick, special tool C–4755, sepa-
rate one end of weatherstrip from retainer channel.
(3) Separate weatherstrip from vehicle (Fig. 45).
Fig. 45 Rear Side Rail Weatherstrip
INSTALLATION
(1) Position weatherstrip on vehicle.
(2) Push weatherstrip into retainer channel, align-
ing embossment on backside of weatherstrip to cor-
ner of retainer.
(3) Lower convertible top.
(4) Adjust position of weatherstrip so that weath-
erstrip is butted tightly against quarter panel and
center side rail weatherstrip.
(5) Secure convertible top.
SUN VISOR
REMOVAL
(1) Disengage sun visor from sun visor support.
(2) Remove screws holding sun visor to header
panel.
(3) Disconnect lighted vanity mirror and universal
garage door opener wiring, if so equipped.
(4) Separate sun visor from vehicle (Fig. 46).
INSTALLATION
(1) Position sun visor to vehicle.
(2) Connect lighted vanity mirror and universal
garage door opener wiring, if so equipped.
(3) Install screws holding sun visor to header
panel.
(4) Engage sun visor to sun visor support
BODY 23 - 39