Chrysler 1997 Stratus Convertible RHD Service Manual page 805

MOUNTING ADAPTER 6865 POST 6886
JX
REMOVAL AND INSTALLATION (Continued)
(2) Using a suitable tool, move camshaft as far
rearward as it will go.
(3) Zero dial indicator (Fig. 41).
(4) Move camshaft as far forward as it will go.
(5) End play travel: 0.1 - 0.2 mm (0.004 - 0.008
inch.). Max. Travel: 0.4 mm (0.016 in.)
Fig. 41 Camshaft End Play
VALVE SPRINGS AND SEALS IN VEHICLE
REMOVAL
(1) Remove rocker arm shafts assemblies as previ-
ously outlined in this section.
(2) Rotate crankshaft until piston is at TDC on
compression.
(3) With air hose attached to adapter tool installed
in spark plug hole, apply 90-120 psi air pressure.
(4) Use Special Tool MD-998772A with Mounting
Post 6886, Forcing Screw Arm 6887, Forcing Screw
6765 and adapter 6865 (Fig. 42) to compress valve
springs and remove valve locks.
(5) Remove valve spring.
(6) Remove valve stem seal by using a valve stem
seal tool.
Fig. 42 Valve Springs—Removing andInstalling
FORCING FORCING ARM 6887 SCREW 6765 SCREW
INSTALLATION
installation outlined in this section.
Post 6886, Forcing Screw Arm 6887, Forcing Screw
6765 and adapter 6865 (Fig. 42) to compress valve
springs only enough to install locks. Correct align-
ment of tool is necessary to avoid nicking valve stems
(air pressure required), piston at TDC.
as previously outlined in this section.
lined in this section.
VALVE AND VALVE SEALS—HEAD OFF
C-3422B with adapter 6526 or equivalent, remove
spring retainer locks, retainer, valve spring, and
valve (Fig. 44).
(1) Install valve seal (Fig. 43) as outlined in valve
(2) Use Special Tool MD-998772A with Mounting
Fig. 43 Valve Stem Seals—Installed
(3) Install rocker arm and lash adjuster assemblies
(4) Install cylinder head cover as previously out-
Fig. 44 Valves Removal—Typical
(1) With valve spring compressor Special Tool
SPECIAL MD998774 TOOL
2.5L ENGINE 9 - 69