Chrysler 1997 Stratus Convertible RHD Service Manual page 1101

POWER POWER WINDOW MOTOR FRONT DOOR WINDOW REGULATOR WINDOW LIFT CHANNEL FRONT DOOR REGULATOR GLASS DOOR NUT NUT
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 17 Regulator Lift Channel
Fig. 18 Roller Channel
Fig. 19 Power Window Regulator
(4) Install bolt at rear of roller channel. Make sure
that bolt is aligned to mark on inner door panel
made previously.
(5) Tighten front and rear bolts of roller channel.
ROLLER CHANNEL FRONT DOOR
(6) Install nuts holding regulator lift channel to
door glass.
(7) Verify glass fit and operation. Adjust door
glass, if necessary.
(8) Connect wire connector to power window motor.
(9) Install door trim panel and water shield.
WINDOW INNER BELT STABILIZER
REMOVAL
(1) Remove door trim panel.
(2) Remove nut holding inner belt stabilizer to
door panel.
(3) Separate inner belt stabilizer from door. (Fig.
20)
Fig. 20 Inner Belt Stabilizer
INSTALLATION
Reverse the preceding operation. Adjust inner belt
stabilizer against glass with enough tension to allow
free up and down movement.
REAR VERTICAL GUIDE BAR
REMOVAL
(1) Remove door trim panel and watershield.
(2) Remove nut holding top of guide bar to inner
door panel.
(3) Using a suitable allen-wrench, hold jack screw
stationary while removing nut holding bottom of
guide bar to inner door panel.
(4) Separate guide bar from vehicle and remove
through access hole in inner door panel (Fig. 21).
INSTALLATION
(1) If a new guide bar is being installed, preset
bottom jack screw using old guide bar as a reference.
(2) Position rear guide bar on vehicle.
(3) Using a suitable allen-wrench, hold jack screw
stationary while installing nut holding bottom of
guide bar to inner door panel.
INNER BELT STABILIZER
BODY 23 - 31