Chrysler 1997 Stratus Convertible RHD Service Manual page 351

RADIATOR CLOSURE PANEL FRONT BUMPER FASCIA HEADLAMP MODULE
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 3 Headlamp Module
(3) Rotate park/turn signal lamp socket one quar-
ter turn clockwise.
(4) Engage wire connector to headlamp bulb
socket.
(5) Position headlamp module to radiator closure
panel.
(6) Install screws holding headlamp module to
radiator closure panel.
TAIL/STOP, TURN SIGNAL, BACKUP AND
SIDEMARKER LAMPS
REMOVAL
(1) Release trunk latch and open trunk lid.
(2) Remove trunk lining as necessary to gain
access to tail lamp nuts.
(3) Remove plastic nuts holding tail lamp to rear
closure panel.
(4) Separate lamp from opening in quarter panel
(Fig. 4).
(5) Rotate bulb sockets counterclockwise one quar-
ter turn.
(6) Pull bulb sockets from back of lamp.
(7) Separate tail/stop, turn signal,backup and side-
marker lamps from vehicle.
INSTALLATION
(1) Position tail/stop, turn signal, backup and side-
marker lamp to vehicle.
(2) Push bulb sockets into back of lamp.
(3) Rotate bulb sockets clockwise one quarter turn.
(4) Position lamp to opening in quarter panel.
(5) Install plastic nuts to hold tail lamp to rear clo-
sure panel in the following sequence: outboard, cen-
ter, inboard.
(6) Install trunk lining.
FRONT MAP LAMP
The front map lamp is not a serviceable compo-
nent. If the front map lamp does not operate prop-
erly, the rear view mirror assembly must be replaced.
GLOVE BOX LAMP
REMOVAL
(1) Release glove box latch and open glove box.
(2) Reach inside glove box to rear side of glove box
lamp and release tabs holding lamp to instrument
panel.
(3) Pull lamp from glove box.
(4) Disengage wire connector from lamp.
(5) Separate lamp from vehicle.
INSTALLATION
(1) Position lamp to vehicle.
(2) Engage wire connector from lamp.
(3) Push lamp into opening in glove box.
ASH RECEIVER/CUP HOLDER LAMP
REMOVAL
(1) Using a small, flat bladed pry tool inserted into
slot in lamp bezel, release tab holding lamp to cubby
bin.
(2) Pull bezel and lamp assembly from cubby bin.
(3) Disengage wire connector from lamp assembly.
(4) Separate lamp assembly from vehicle.
INSTALLATION
(1) Position lamp assembly to vehicle.
(2) Engage wire connector to lamp assembly.
(3) Push bezel and lamp assembly into cubby bin
to engage tabs.
FLOOR CONSOLE COURTESY LAMP
REMOVAL
(1) Using a small, flat bladed tool inserted into slot
in top edge of courtesy lamp, separate courtesy lamp
from floor console (Fig. 5).
(2) Rotate bulb socket counterclockwise one quar-
ter turn.
(3) Pull bulb socket from courtesy lamp (Fig. 6).
(4) Separate console courtesy lamp from vehicle.
INSTALLATION
(1) Separate console courtesy lamp from vehicle.
(2) Push bulb socket into courtesy lamp.
(3) Rotate bulb socket clockwise one quarter turn.
(4) Position lower edge of courtesy lamp to floor
console.
(5) Snap courtesy lamp into floor console.
LAMPS 8L - 13