Chrysler 1997 Stratus Convertible RHD Service Manual page 339

JX
BULB APPLICATION . . . . . . . . . . . . . . . . . . . . . 19
EXTERIOR LAMP SWITCHES . . . . . . . . . . . . . . . 7
GENERAL LIGHTING DIAGNOSIS
HEADLAMP AND FOG LAMP ALIGNMENT . . . . 4
GENERAL INFORMATION
DIAGNOSTIC PROCEDURES
GENERAL INFORMATION
GENERAL INFORMATION
JX vehicles use lighting on the interior and exte-
rior of the vehicle for illuminating and indicating
purposes. Lighting circuits are protected by fuses or
circuit breakers. Lighting circuits require an overload
protected power source, on/off device, lamps and body
ground to operate properly. Plastic lamps require a
wire in the harness to supply body ground to the
lamp socket. Lamp sockets that are exposed to mois-
ture should be coated with Mopar
Grease, or equivalent, to avoid corrosion. If a socket
has become corroded, clean socket and bulb base with
abrasive fiber sanding pad or metallic bristle brush.
Replace sockets and bulbs that are deformed from
corrosion that could prevent continuous body ground.
Wire connectors can make intermittent contact or
become corroded. Before coupling wire connectors,
inspect the terminals inside the connector. Male ter-
minals should not be bent or disengaged from the
insulator. Female terminals should not be sprung
open or disengaged from the insulator. Bent and
sprung terminals can be repaired using needle nose
pliers and pick tool. Corroded terminals appear
chalky or green. Corroded terminals should be
replaced to avoid recurrence of the problem symp-
toms. Wire connector terminals should be coated with
Mopar Multi-purpose Grease, or equivalent, to avoid
corrosion.
LAMPS
CONTENTS
page
. . . . . . . . . . . 1
GENERAL LIGHTING DIAGNOSIS
page
. . . . . . . . . . . . . . 2
Multi-purpose
LAMP BULB SERVICE . . . . . . . . . . . . . . . . . . . . 8
LAMP SERVICE
LAMP SYSTEMS
INDEX
GENERAL INFORMATION . . . . . . . . . . . . . . . . . 1
SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . 1
Begin electrical system failure diagnosis by testing
related fuses and circuit breakers in the fuse block
and engine compartment. Verify that bulbs are in
good condition and test continuity of the circuit
ground. Refer to Group 8W, Wiring Diagrams, for
component location and circuit information.
SAFETY PRECAUTIONS
WARNING: EYE PROTECTION SHOULD BE USED
WHEN SERVICING GLASS COMPONENTS. PER-
SONAL INJURY CAN RESULT.
CAUTION: Do not touch the glass of halogen
bulbs with fingers or other possibly oily surface,
reduced bulb life will result. Do not use bulbs with
higher candle power than indicated in the Bulb
Application table at the end of this group. Damage
to lamp can result. Do not use fuses, circuit break-
ers or relays having greater amperage value than
indicated on the fuse panel or in the Owners Man-
ual.
When it is necessary to remove components to ser-
vice another, it should not be necessary to apply
excessive force or bend a component to remove it.
Before damaging a trim component, verify hidden
fasteners or captured edges are not holding the com-
ponent in place.
LAMPS
. . . . . . . . . . . . . . . . . . . . . . . . 12
. . . . . . . . . . . . . . . . . . . . . . . 17
8L - 1
page
page