Chrysler 1997 Stratus Convertible RHD Service Manual page 1119

REAR SEAT CROSSMEMBER REAR SEAT CROSSMEMBER AMPLIFIER WIRING SLIT SEAT WIRING SLIT DOOR SILL DOOR SILL CARPET
DOOR SILL CARPET
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 67 Carpet Fasteners
Fig. 68 Carpet
(3) Feed wiring connectors for the seats and ampli-
fier, if equipped, through slits in carpet.
(4) Install plastic sill retainers in metal clips along
door sill panel.
(5) Install wiring troughs holding carpet at out-
board ends of rear seat crossmember.
(6) Install amplifier on passenger side of floor pan,
if so equipped.
(7) Install quarter trim panels.
(8) Install cowl trim panels.
(9) Install door sill trim panels.
(10) Install floor console and forward instrument
panel console.
(11) Install rear seat cushion.
(12) Install front seats.
(13) Raise and secure convertible top.
QUARTER PANEL OUTER BELT WEATHERSTRIP/
MOLDING
REMOVAL
(1) Lower convertible top to midway position.
(2) Lower quarter glass to full down position.
(3) Remove quarter trim panel.
(4) Remove screws holding quarter panel outer
belt weatherstrip/molding to outer quarter panel.
(5) Loosen appropriate side of upper deck molding.
(6) Pull upward at one end of outer belt weather-
strip to separate from vehicle.
(7) Separate outer belt weatherstrip from vehicle.
INSTALLATION
(1) Position quarter panel outer belt weatherstrip/
molding on vehicle.
(2) Push outer belt weatherstrip/molding down-
ward until weatherstrip/molding is fully seated.
(3) Install screws holding outer belt weather-strip
to outer quarter panel.
(4) Tighten fasteners for upper belt molding.
(5) Install quarter trim panel.
(6) Raise and secure convertible top.
UPPER DECK MOLDING
REMOVAL
(1) Lower convertible top to midway position.
(2) Remove screws holding upper deck molding to
rear deck panel above convertible top rear attach-
ment.
(3) Open trunk.
(4) Remove screws holding upper deck molding to
rear deck panel inside trunk water trough.
(5) Disconnect wire connector for CHMSL.
(6) Separate upper deck molding from vehicle.
INSTALLATION
(1) Position upper deck molding on vehicle.
(2) Connect wire connector for CHMSL.
(3) Install screws holding upper deck molding to
rear deck panel inside trunk water trough.
(4) Install screws holding upper deck molding to
rear deck panel above convertible top rear attach-
ment.
(5) Raise and secure convertible top.
FOLDING TOP HEADLINING
REMOVAL
(1) Raise convertible top to midway position.
(2) Remove convertible top header trim panel.
(3) Remove screws holding headlining to convert-
ible top header panel.
BODY 23 - 49