Chrysler 1997 Stratus Convertible RHD Service Manual page 1090

FRONT TURN TURN DART TOWARD REAR (HEADER MOVES FORWARD FRONT-TO-CENTER REARWARD AND UP) ADJUSTING SCREW (HEADER DART SERRATED PLATE BALANCE LINK TOP HEADER SET SCREW DOWEL PIN TOWARD AND UP) MOVES FRONT CAM RAIL
23 - 20 BODY
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Position hydraulic line to vehicle.
(2) Connect hydraulic line to hydraulic pump.
(3) Connect hydraulic line to hydraulic cylinders.
(4) Fill hydraulic system. Check for leaks and
proper operation.
(5) Install quarter trim panels
(6) Install rear seat cushion and rear seat back.
ADJUSTMENTS
CONVERTIBLE TOP ADJUSTMENTS
Refer to (Fig. 7) to determine which adjustment is
required. Refer to the appropriate procedure for more
information.
DOWEL PIN ADJUSTMENTS
(1) Loosen dowel pins (Fig. 8).
(2) Position dowel pins to the center of the receiver
holes in the windshield header.
(3) Tighten dowel pins and verify adjustment.
NOTE: Refer to Cam Adjustment or Balance Link
Adjustment paragraphs of this section to adjust for-
ward or rearward position of the top header.
LATCH HOOK ADJUSTMENT
If the convertible top latching effort is excessive, it
can be reduced by lengthening the latch hook (Fig.
8). The top header weatherstrip requires enough
compression to prevent air and water leaks. Adjust
latch hook to achieve reasonable latching effort and
proper sealing.
Fig. 7 Adjustment Locations
35.56 mm MAX 25.4 mm MIN SET SCREW DOWEL PIN HEADER
Fig. 8 Roof Latch and Guide Dowel Pin
JX