Chrysler 1997 Stratus Convertible RHD Service Manual page 1111

HEADER A PILLAR WEATH DOOR OPENING TRIM WELT ERSTRIP
DOOR OPENING FLANGE
JX
REMOVAL AND INSTALLATION (Continued)
(3) Engage clip on trim panel to slots in header
panel.
(4) Install inside rear view mirror.
(5) Install sun visor.
DOOR OPENING TRIM WELT
REMOVAL
(1) Using trim stick, special tool C–4755, remove
one end of door opening trim welt from door opening
flange.
(2) Separate welt from vehicle (Fig. 50).
Fig. 50 Door Opening Trim Welt
INSTALLATION
(1) Position door opening trim welt on vehicle.
(2) Butt end of welt to edge of header/A–pillar
weatherstrip.
(3) Push door opening welt onto door opening
flange.
COWL TRIM PANEL
REMOVAL
(1) Remove door sill trim panel.
(2) Remove screws holding cowl trim panel to
inner cowl panel.
(3) Separate cowl trim panel from vehicle (Fig. 51).
INSTALLATION
(1) Position cowl trim panel to vehicle.
(2) Install screws holding cowl trim panel to inner
cowl panel.
(3) Install door sill trim panel.
DOOR SILL TRIM PANEL
REMOVAL
(1) Using a fork–type prying tool, disengage clips
holding door sill trim panel to door sill (Fig. 52).
RIGHT COWL TRIM PANEL DOOR OPENING FLANGE DOOR SILL TRIM PANEL SECTION A A DOOR SILL
LEFT COWL TRIM PANEL LOCATING TAB
Fig. 51 Cowl Trim Panel
(2) Starting at one end of sill trim panel, pull
upward on sill trim panel in order to disengage clips
holding sill trim panel to door opening flange.
(3) Separate door sill trim panel from vehicle.
Fig. 52 Door Sill Trim Panel
INSTALLATION
(1) Position door sill trim panel on vehicle.
(2) Align locating rib to net against cowl trim
panel.
(3) Engage clips on sill trim panel to door opening
flange.
NOTE: Check that
panel weatherstrips are properly positioned. Incor-
rect positioning will interfere with clip engagement
to door opening flange and damage door sill trim
panel.
(4) Engage clips holding sill trim panel to door sill.
BODY
header/A–pillar and
23 - 41
quarter