Chrysler 1997 Stratus Convertible RHD Service Manual page 1076

COWL A-PILLAR
23 - 6 BODY
REMOVAL AND INSTALLATION (Continued)
as necessary. Push windshield inward until molding
is flush to roof line and A-pillars (Fig. 5).
(20) Clean access urethane from exterior with
Mopar Super Kleen or equivalent.
(21) Apply 150 mm (6 in.) lengths of 50 mm (2 in.)
masking tape spaced 250 mm (10 in.) apart to hold
molding in place until urethane cures.
(22) Install cowl cover and wipers.
(23) Install inside rear view mirror.
(24) After urethane has cured, remove tape strips
and water test windshield to verify repair.
Fig. 2 Center Windshield and Mark at Support
WINDSHIELD MARKS
Spacers
SUPPORT SPACER
WINDSHIELD OPEN- A-PILLAR FENCE
Fig. 3 Work Surface Set up and Molding Installation
Fig. 4 Position Urethane Compression Spacers—
Fig. 5 Lower Windshield Into Position
ING ROOF PANEL SPACERS WINDSHIELD
Typical
JX
THANE APPLIED WITH REFERENCE URE- MARKS