Chrysler 1997 Stratus Convertible RHD Service Manual page 1125

ROLLER CHANNEL ADJUST- IN/OUT JACK SCREW IN/OUT JACK SCREW FORWARD UP-STOP REAR UP-STOP MENT
JX
ADJUSTMENTS (Continued)
NOTE: Remove only one weatherstrip section at a
time or the glass to weatherstrip retainer measure-
ments will not be accurate.
(7) Verify that the top edge of the door glass is
beneath the lip of the weatherstrip.
(8) Tighten all fasteners.
MIRROR STANCHION MIRROR STANCHION DOOR GLASS DOOR GLASS FLUSH DOOR
Fig. 80 Inboard/Outboard Glass Adjustment
GLASS—FRONT/REAR ADJUSTMENT
(1) Remove door trim panel and water shield.
(2) Lower door glass to gain access to glass attach-
ments.
(3) Loosen three glass attachment bolts.
(4) Raise door glass and position correctly (Fig. 77)
and (Fig. 81).
(5) Tighten the two accessible glass fasteners in
the full up position.
(6) Lower door glass and tighten the remaining
glass fastener.
(7) Raise glass to top of travel and verify position-
ing (Fig. 77) and (Fig. 81).
(8) To verify proper fit of the door glass to the
header/A-pillar weatherstrip,
weatherstrip near mirror flag and another near the
front upper corner of the door glass.
and the weatherstrip. There should be slight ten-
sion on the paper.
Fig. 81 Front/Rear Glass Position
(a) Lower door glass slightly.
(b) Place a paper strip between the glass and
(c) Raise glass to full up position.
(d) Pull the strip from between the door glass
BODY 23 - 55