Chrysler 1997 Stratus Convertible RHD Service Manual page 1105

DOOR LATCH ROD DOOR LATCH DOOR LATCH LATCH ROD LOCK ROD
INSIDE LOCK BUTTON DOOR DOOR
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 30 Latch and Lock Rod Clips
Fig. 31 Lock and Latch Rods At Door Latch
Fig. 32 Door Latch
INSTALLATION
CAUTION: Do not close door before adjusting the
door latch. Door may fail to re–open.
DOOR LOCK CYLINDER DOOR
DOOR LOCK CYLINDER
(1) Position door latch on vehicle.
(2) Install screws holding door latch to door end
frame.
(3) Engage wire connector to power door lock
motor.
(4) Connect lock and latch rods from outside door
handle and key cylinder at door latch.
(5) Engage lock and latch rods to clips on inner
door panel.
(6) Connect lock rod from lock button bellcrank.
(7) Adjust door latch.
(8) Verify operation of door latch. Readjust if nec-
essary.
(9) Install door trim panel and watershield.
DOOR LOCK CYLINDER
REMOVAL
(1) Remove outside door handle.
(2) Remove clip holding lock cylinder to outside
door panel (Fig. 33).
(3) Disengage clip holding link to key cylinder.
(4) Separate lock cylinder from outer door panel.
Fig. 33 Door Lock Cylinder
INSTALLATION
(1) Position lock cylinder and gasket in door outer
panel.
(2) Install clip holding lock cylinder to outside door
panel.
(3) Engage link to key cylinder.
(4) Install outside door handle.
DOOR LATCH STRIKER
REMOVAL
(1) Mark outline of door latch striker on B–pillar
to aid in installation.
(2) Remove screws holding door latch striker to
B–pillar (Fig. 34).
(3) Separate latch striker from vehicle.
BODY 23 - 35