Chrysler 1997 Stratus Convertible RHD Service Manual page 1098

LOWER SPLASH PUSH-IN SHIELD TENER FASCIA FAS- BATTERY NUT-SNAP SPLASH SHIELD
23 - 28 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 9 Left Front Wheelhouse Splash Shield
INSTALLATION
Reverse the preceding operation.
ACCESSORY DRIVE BELT SPLASH SHIELD
REMOVAL
(1) Remove screw holding accessory drive belt
splash shield to front fender (Fig. 10).
(2) Remove push-in fasteners holding accessory
drive belt splash shield to frame rail.
(3) Separate accessory drive belt splash shield
from vehicle.
INSTALLATION
Reverse the preceding operation.
RIGHT FRONT WHEELHOUSE SPLASH SHIELD
REMOVAL
(1) Hoist and support vehicle on safety stands.
(2) Remove right front wheel.
(3) Remove screws holding wheelhouse splash
shield to front fender lip (Fig. 10).
(4) Remove screws holding wheelhouse splash
shield to front bumper fascia.
(5) Remove push-in fastener holding wheelhouse
splash shield to fender at rocker panel.
(6) Remove push-in fasteners holding wheelhouse
splash shield to fender support.
(7) Separate wheelhouse splash shield from vehi-
cle.
INSTALLATION
Reverse the preceding operation.
FENDER WHEELHOUSE SPLASH SHIELD WHEELHOUSE SPLASH SHIELD PUSH-IN FASTENER NUT-SNAP
Fig. 10 Right Front Wheelhouse Splash Shield
DOOR
REMOVAL
NOTE: The retaining clips used on the door hinge
pins are not to be re-used. Verify availability prior to
proceeding.
(1) Open and support door on a suitable lifting
device.
(2) Disengage wire connector at hinge pillar.
(3) Remove bolts holding door check strap to hinge
pillar.
(4) Remove clip holding hinge pin in lower door
hinge.
(5) Remove pin from lower hinge (Fig. 11).
(6) Remove clip holding hinge pin in upper hinge.
(7) Remove pin from upper hinge (Fig. 11).
(8) Separate door from vehicle.
INSTALLATION
(1) Apply Mopar Multimileage Grease to inside of
door hinge bushings.
(2) Position door on vehicle and install pin in
upper hinge. Align knurling on hinge pin with the
grooves in the door hinge prior to driving in the
hinge pin.
(3) Install pin in lower hinge.
NOTE: Verify that head of each hinge pin is fully
seated into door hinge.
(4) Install new clip holding hinge pin in upper
hinge.
FENDER ACCESSORY BELT SPLASH SHIELD PUSH-IN FAS- TENER FASCIA DRIVE
JX