Chrysler 1997 Stratus Convertible RHD Service Manual page 937

SPLASH SHIELD
JX
REMOVAL AND INSTALLATION (Continued)
POWER STEERING PUMP 2.5 L ENGINE
WARNING: POWER STEERING OIL, ENGINE COM-
PONENTS AND EXHAUST
EXTREMELY HOT IF ENGINE HAS BEEN RUNNING.
DO NOT START ENGINE WITH ANY LOOSE OR DIS-
CONNECTED HOSES, OR ALLOW HOSES TO
TOUCH HOT EXHAUST MANIFOLD OR CATALYST.
REMOVE
(1) Remove battery cable from (-) negative post on
battery and isolate cable.
(2) Siphon as much power steering fluid as possi-
ble out of the remote power steering fluid reservoir.
(3) Remove the power steering fluid supply hose
from the power steering fluid reservoir. Fluid supply
hose will be removed with the power steering pump.
(4) Raise vehicle.
(5) Remove right front tire from vehicle.
(6) Remove accessory drive splash shield (Fig. 35)
from the right front wheel well.
Fig. 35 Accessory Drive Splash Shield
(7) Remove the power steering fluid pressure hose
from pressure fitting on power steering pump (Fig.
36). Let remaining power steering fluid drain out of
the power steering fluid supply hose, power steering
pump and power steering fluid pressure hose. After
power steering fluid has drained out of pump
and hose, install a cap on the power steering
pressure hose and a plug in the power steering
pump pressure fitting.
(8) Remove the antilock brakes hydraulic control
unit heat shield (Fig. 37) from the hydraulic control
unit mounting bracket.
(9) Remove bolt at adjusting slot in accessory drive
mounting bracket, (Fig. 38) attaching back of power
steering pump to the bracket.
(10) Remove bolt at adjustment slot, (Fig. 39)
attaching the power steering pump front mounting
SYSTEM MAY BE
POWER STEERING PRES ABS HYDRAULIC CONTROL POWER FLOW CONTROL VALVE FIT POWER STEERING PRES POWER STEERING PUMP UNIT HEAT SHIELD STEERING ADJUSTING SLOT SUPPLY HOSE SURE HOSE SURE HOSE FLUID BOLT TING
ACCESSORY DRIVE MOUNT- POWER STEERING PUMP POWER STEERING PUMP ING BRACKET
Fig. 36 Power Steering Fluid Pressure Hose
Attachment To Pump
Fig. 37 Hydraulic Control Unit Heat Shield
Fig. 38 Power Steering Pump Rear Mounting Bolt
bracket to cast aluminum accessory drive bracket on
engine. Then remove bolt (Fig. 39) at top of power
STEERING 19 - 23