Chrysler 1997 Stratus Convertible RHD Service Manual page 906

14 - 52 FUEL SYSTEM
REMOVAL AND INSTALLATION (Continued)
REMOVAL
(1) Disconnect electrical connector from sensor.
(2) Remove sensor.
INSTALLATION
(1) Install sensor. Tighten sensor to 28 N·m (20 ft.
lbs.) torque.
(2) Attach electrical connector to sensor.
DUTY CYCLE EVAP PURGE SOLENOID
REMOVAL
(1) If equipped with speed control, remove speed
control servo and bracket. Cover the ends of the
speed control servo studs to allow easier ser-
vice of the purge solenoid.
(2) Disconnect electrical connector from solenoid.
(3) Disconnect vacuum tubes from solenoid.
(4) Remove solenoid from bracket by pulling up on
solenoid.
INSTALLATION
NOTE: To eliminate a chance of transmitting noises
into the body, make sure the hood release cable is
installed in all of its clamps. Make sure the solenoid
is not touching a brake line.
The top of the solenoid has TOP printed on it. The
solenoid will not operate unless it is installed cor-
rectly.
(1) Install solenoid on bracket.
(2) Connect vacuum tube to solenoid.
(3) Connect electrical connector to solenoid.
(4) Install speed control servo and bracket. Tighten
nuts to 9 N·m (80 in. lbs.).
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR
2.4L
The MAP sensor attaches to the intake manifold
plenum (Fig. 75).
2.5L
The MAP sensor attaches to the intake manifold
plenum (Fig. 76).
REMOVAL
(1) Disconnect electrical connector from MAP sen-
sor.
(2) Remove sensor mounting screws.
(3) Remove sensor.
INSTALLATION
(1) Insert sensor into intake manifold while mak-
ing sure not to damage O-ring seal.
(2) Tighten mounting screws to:
2.4L
(3) 2 N·m (20 in. lbs.) torque.
2.5L
INTAKE TEMPERATURE INTAKE MANIFOLD SENSOR AIR MAP SENSOR
Fig. 75 Intake Air Temperature Sensor and MAP
Sensor—2.4L
Fig. 76 Intake Air Temperature Sensor and MAP
Sensor—2.5L
(4) 3.4 N·m (30 in. lbs) torque.
(5) Attach electrical connector to sensor.
POWERTRAIN CONTROL MODULE SERVICE
The PCM attaches to a bracket between the air
cleaner housing and Power Distribution Center
(PDC).
REMOVAL
(1) Disconnect negative
jumper terminal (Fig. 77).
(2) Disconnect both 40-way connectors from PCM.
(3) Remove screws attaching PCM to bracket (Fig.
78).
(4) Lift PCM up to remove it from vehicle.
INSTALLATION
(1) Install PCM. Tighten mounting screws.
(2) Attach both 40-way connectors to PCM.
MAP SEN- SOR PERATURE SENSOR INTAKE THROTTLE BODY AIR
cable from auxiliary
TEM-
JX