Chrysler 1997 Stratus Convertible RHD Service Manual page 323

JX
DIAGNOSIS AND TESTING (Continued)
CONDITION
SYSTEM DOES NOT FLASH
ON ONE SIDE, INDICATOR
LAMP FLASHES AT
DOUBLE NORMAL RATE.
INDICATOR LAMP FLASHES
AT DOUBLE NORMAL
RATE. EXTERNAL
LAMP-DIM AND FLASHES
RAPIDLY OR NO FLASH.
HAZARD WARNING
MALFUNCTION/SYSTEM
DOES NOT FLASH.
INDICATOR LAMP FLASHES
AT DOUBLE NORMAL
RATE. EXTERNAL LAMP
DOES NOT LIGHT.
SYSTEM DOES NOT FLASH
ON EITHER SIDE.
SYSTEM DOES NOT
CANCEL AFTER
COMPLETION OF TURN.
EXTERNAL LAMPS
OPERATE PROPERLY, NO
INDICATOR LAMP
OPERATION.
COMBINATION FLASHER DIAGNOSIS
POSSIBLE CAUSES
1. Faulty external lamp.
2. Poor ground at lamp.
3. Open circuit in wiring to external
lamp.
4. Faulty contact in switch.
1. Loose or corroded external lamp
connection.
2. Poor ground circuit at external
lamp.
1. Faulty fuse.
2. Faulty flasher.
3. Open circuit in feed wire to switch.
4. Faulty contact in switch.
5. Open or grounded circuit in wiring
to external lamps.
1. Open circuit in wire to external
lamp.
2. Burned out lamp.
1. Faulty fuse.
2. Faulty flasher unit.
3. Loose bulkhead connector.
4. Loose or faulty rear wiring
Harness or terminals.
5. Open circuit to flasher unit.
6. Open circuit in feed wire to turn
signal switch.
7. Faulty switch connection in switch.
8. Open or grounded circuit in wiring
to external lamps.
9. Burned out lamps.
1. Broken cancelling finger on switch.
2. Broken or missing cancelling cam
on clockspring.
3. Sticking cancelling finger on
multifunction switch.
1. Faulty indicator lamp in instrument
cluster.
Fig. 2
TURN SIGNAL AND FLASHERS
CORRECTION
1. Replace lamp.
2. Check and/or replace wiring.
3. Replace wiring/ harness. Check
connectors.
4. Replace multifunction switch.
1. Replace socket/harness.
2. Replace wiring/harness. Check
connectors.
1. Replace fuse.
2. Replace flasher.
3. Replace wiring/harness. Check
connectors.
4. Replace multifunction switch.
5. Replace wiring/harness.
1. Replace wiring/harness.
2. Replace lamp.
1. Replace fuse.
2. Replace flasher.
3. Tighten connector.
4. Replace wiring/harness.
5. Check connectors, replace wiring/
harness.
6. Check connectors, replace wiring/
harness.
7. Replace switch.
8. Replace wiring/harness.
9. Replace lamps.
1. Replace multifunction switch.
2. Replace clockspring.
3. Replace multifunction switch.
1. Replace lamp.
8J - 3