Chrysler 1997 Stratus Convertible RHD Service Manual page 774

REAR CRANKSHAFT BEARING WASHER M12–1.75 SCREW- DRIVER FROM AND 150 MM BOLT, SEAL TOOL 6792 SPECIAL THRUST ENGINE BLOCK
9 - 38 2.4L ENGINE
REMOVAL AND INSTALLATION (Continued)
Fig. 69 Crankshaft Damper—Installation
Fig. 70 Rear Crankshaft Oil Seal—Removal
INSTALLATION
CAUTION: If burr or scratch is present on the
crankshaft edge (chamfer), cleanup with 400 grit
sand paper to prevent seal damage during installa-
tion of new seal.
NOTE: When installing seal, no lube on seal is
needed.
(1) Place Special Tool 6926-1 on crankshaft. This is
a pilot tool with a magnetic base (Fig. 71).
(2) Position seal over pilot tool. Make sure you can
read the words THIS SIDE OUT on seal (Fig. 71).
Pilot tool should remain on crankshaft during instal-
REAR CRANKSHAFT SEAL ENGINE BLOCK CRANK- SHAFT REAR SHAFT SCREW- METAL CASE DUST LIP PRY IN THIS DIRECTION CRANK- DRIVER SEAL SPECIAL TOOL 6926–1
lation of seal. Ensure that the lip of the seal is facing
towards the crankcase during installation.
CAUTION: If the seal is driven into the block past
flush, this may cause an oil leak.
(3) Drive the seal into the block using Special Tool
6926-2 and handle C-4171 (Fig. 72) until the tool bot-
toms out against the block (Fig. 73).
Fig. 71 Rear Crankshaft Seal and SpecialTool 6926-1
Fig. 72 Crankshaft Seal Special Tool 6926-2
6792–2 INSTALLER SPECIAL 6926–1 PILOT TOOL SPECIAL TOOL
PILOT SEAL
SEAL
JX