Chrysler 1997 Stratus Convertible RHD Service Manual page 392

CONTINUITY Mirror in R Position Mirror in L Position SWITCH POSITION Move Button TERMINALS BETWEEN PIN 1 to 8 PIN 2 to 5 PIN 1 to 6 PIN 1 to 7 PIN 1 to 5 PIN 2 to 4 PIN 1 to 3 PIN 2 to 6 PIN 1 to 4 PIN 2 to 5 PIN 1 to 6 PIN 2 to 3 PIN 2 to 8 PIN 2 to 7 PIN 1 to 5 PIN 2 to 6
8T - 2 POWER MIRRORS
DIAGNOSIS AND TESTING (Continued)
Fig. 2 Mirror Motor Test
(3) Using an ohmmeter, test for continuity between
the terminals of the switch as shown in the Mirror
Switch Test (Fig. 3).
(4) If test results are not obtained as shown in the
(Fig. 3), replace the switch.
Fig. 3 Mirror Switch Test
REMOVAL AND INSTALLATION
INSIDE MIRROR/READING LAMP ASSEMBLY
REMOVAL
(1) Remove attaching screws from header (Fig. 4).
(2) Lower mirror, and disconnect the wire harness
connector.
(3) Remove mirror assembly.
INSTALLATION
For installation, reverse the above procedure.
ATTACHING SCREWS PRY OFF LENS
Fig. 4 Inside Mirror/Reading Lamps
INSIDE MIRROR/READING LAMP BULB/LENS
REMOVAL
(1) Using a small thin blade tool, pry at the center
of the lens nearest the mirror to remove lens (Fig. 4).
(2) Remove lamp and replace if necessary.
INSTALLATION
Install lens by setting into position and apply pres-
sure until it is locked into position.
MIRROR ASSEMBLY
REMOVAL
(1) For door trim panel and mirror removal, refer
to Group 23, Body.
(2) Disconnect mirror.
(3) Remove attaching nuts.
(4) Test operation of mirror before installing door
trim panel.
INSTALLATION
For installation, reverse the above procedures.
MIRROR SWITCH
REMOVAL
(1) Place a small flat blade tool into the slot above
the L–R selector end of the switch. Pushing against
the switch and pulling upward will release the
mounting clip located directly below. This will allow
the switch to be release from the door trim panel.
(2) Disconnect wire connector.
INSTALLATION
For installation, reverse the above procedures.
JX