Chrysler 1997 Stratus Convertible RHD Service Manual page 1104

DOOR CLIP
MIRROR FLAG/GLASS CHANNEL
23 - 34 BODY
REMOVAL AND INSTALLATION (Continued)
SIDE VIEW MIRROR FLAG/DOOR GLASS CHANNEL
REMOVAL
(1) Remove side view mirror.
(2) Remove door trim panel.
(3) Remove door glass.
(4) Remove door outer belt weatherstrip.
(5) Remove screws holding mirror flag/door glass
channel to outer door panel (Fig. 28).
(6) Remove nut holding top of mirror flag/door
glass channel to inner door panel.
(7) Using a suitable allen-wrench, hold jack screw
stationary while removing nut holding bottom of mir-
ror flag/door glass channel to inner door panel.
(8) Separate from vehicle and remove through
opening in top of door.
Fig. 28 Side View Mirror Flag/Door Glass Channel
INSTALLATION
(1) If installing a new mirror flag/door glass chan-
nel, preset jack–screw using old flag/channel as a ref-
erence.
(2) Position mirror flag/door glass channel on vehi-
cle.
(3) Using a suitable allen-wrench, hold jack screw
stationary while installing nut holding bottom of mir-
ror flag/door glass channel to inner door panel.
(4) Install nut holding top of mirror flag/door glass
channel to inner door panel.
(5) Install screws holding mirror flag/door glass
channel to outer door panel.
(6) Install door outer belt weatherstrip.
(7) Install door glass.
(8) Install side view mirror.
(9) Verify glass fit and operation. Adjust door glass
as necessary.
(10) Install door trim panel.
DOOR CHECK STRAP DOOR FACE
DOOR
DOOR CHECK STRAP
REMOVAL
(1) Remove door trim panel.
(2) Remove watershield as necessary to gain
access.
(3) Remove bolts holding check strap to lower
A–pillar.
(4) Remove bolts holding check strap to door end
frame (Fig. 29).
(5) Separate door check strap from vehicle.
Fig. 29 Door Check Strap
INSTALLATION
(1) Position door check strap on vehicle.
(2) Install bolts holding check strap to door end
frame.
(3) Install bolts holding check strap to lower A-pil-
lar.
(4) Install watershield.
(5) Install door trim panel.
DOOR LATCH
REMOVAL
(1) Remove door trim panel and watershield.
(2) Raise door glass.
(3) Disconnect lock rod from lock button bellcrank.
(4) Disengage lock and latch rods from clips on
inner door panel (Fig. 30).
(5) Disconnect lock and latch rods from outside
door handle and key cylinder at door latch (Fig. 31).
(6) Disengage wire connector from power door lock
motor.
(7) Remove screws holding door latch to door end
frame (Fig. 32).
(8) Separate door latch from vehicle.
JX