Chrysler 1997 Stratus Convertible RHD Service Manual page 1006

OIL TRANSFER SHAFT BAF- FLE OUTPUT GEAR BEARING CUP TOOL 6052 TOOL 6259
21 - 38 TRANSAXLE
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 126 Install Bearing Cone
Fig. 127 Bearing Cup Removed
Fig. 128 Remove Output Gear Bolt
All transaxles utilize a stirrup and retaining strap
that is attached to the output gear. The stirrup pre-
vents the output gear retaining bolt from turning
and backing out of the rear carrier. The strap is used
BEARING CONE TRANSFER SHAFT NEW BEARING CONE PRESS R AM ARBOR
OUTPUT GEAR- BOLT
O-RING OUTPUT RETAINING BOLT GEAR
to hold the stirrup to the output gear and prevent
the stirrup retaining bolts from backing out.
Fig. 129 Output Gear Retaining Bolt Stirrup
STIRRUP
Fig. 130 Stirrup Strap (Align Strap Holes With
Fig. 131 Install Strap Bolts
STIRRUP
(Serration Side Out)
STRAP RETAINING BOLTS RETAINING STRAP
Tapped Gear Holes)
RETAINING S TRAP STIRRUP
JX