Chrysler 1997 Stratus Convertible RHD Service Manual page 408

JX
SERVICE PROCEDURES (Continued)
Fig. 19 Augat Connector Repair
Fig. 20 Using Special Tool 6932
(3) Remove connector locking wedge, if required
(Fig. 21).
Fig. 21 Connector Locking Wedge Tab (Typical)
(4) Position the connector locking finger away
from the terminal using the proper pick from special
8W - 01 GENERAL INFORMATION
tool kit 6680. Pull on the wire to remove the terminal
from the connector (Fig. 22) (Fig. 23).
Fig. 22 Terminal Removal
Fig. 23 Terminal Removal Using Special Tool
(5) Cut the wire 6 inches from the back of the
connector.
(6) Remove 1 inch of insulation from the wire on
the harness side.
(7) Select a wire from the terminal repair assem-
bly that best matches the color wire being repaired.
(8) Cut the repair wire to the proper length and
remove 1 inch of insulation.
(9) Place a piece of heat shrink tubing over one
side of the wire. Make sure the tubing will be long
enough to cover and seal the entire repair area.1
(10) Spread the strands of the wire apart on each
part of the exposed wires.
(11) Push the two ends of wire together until the
strands of wire are close to the insulation.
(12) Twist the wires together.
(13) Solder the connection together using rosin
core type solder only. Do not use acid core solder.
8W - 01 - 11