Chrysler 1997 Stratus Convertible RHD Service Manual page 903

JX
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Attach electrical connectors to idle air control
motor and throttle position sensor.
(2) Install paper gasket.
(3) Position throttle body on intake and install
mounting bolts. Do Not tighten bolts at this time.
(4) Install throttle cable bracket. Do Not tighten
bolts at this time.
(5) Tighten throttle body bolts to 22.5
25 in. lbs.) torque.
(6) Tighten throttle cable bracket bolts to 11.75
2.25 N·m (105 20 in. lbs.) torque.
(7) Install EVAP purge hose to throttle body nipple.
(8) Install cable housing(s) retainer tabs into bracket.
(9) Install throttle body cables by rotating the
throttle lever forward to the wide open position.
(10) Install throttle shield and tighten bolt to 4.5
N·m (40 in. lbs.).
(11) Install air inlet resonator as described in this
section.
THROTTLE BODY—2.5L ENGINE
REMOVAL
(1) Remove air tube from throttle body.
(2) Remove throttle cable from the throttle body
lever (Fig. 66).
Fig. 66 Throttle Cable Attachment to Throttle Body
(3) Push release tang toward dash panel on throt-
tle cable and slide cable out of bracket (Fig. 67).
(4) Slide speed control cable out of bracket, if
equipped (Fig. 67).
(5) Remove EVAP purge hose from nipple on throt-
tle body.
(6) Remove connectors from throttle position sen-
sor and idle air control motor.
(7) Remove bolts holding throttle body to intake
manifold. Remove throttle body.
SPEED CONTROL CABLE
3 N·m (200
INSTALLATION
(1) Attach electrical connectors to idle air control
motor and throttle position sensor.
(2) Install new gasket.
(3) Position throttle body on intake and install
mounting bolts. Tighten bolts to 28.25 N·m (250 in.
lbs.).
(4) Install speed control cable (if equipped) and
throttle cable into throttle lever.
(5) Install cables into cable bracket.
(6) Install air inlet tube. Tighten clamps to 3 .5
N·m (25 5 in. lbs.) torque.
THROTTLE POSITION SENSOR (TPS)—2.4L
The throttle position sensor attaches to the side of
the throttle body (Fig. 68).
Fig. 68 Throttle Position Sensor and Idle Air Control
REMOVAL
(1) Disconnect EVAP purge hose from throttle
body.
RELEASE TANG
FUEL SYSTEM
Fig. 67 Throttle Cable Attachment
Motor
THROTTLE CABLE
14 - 49