Chrysler 1997 Stratus Convertible RHD Service Manual page 961

MASTER CYLINDER
LEFT STRUT TOWER SPEED CONTROL SERVO
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 2 Remote Ground Cable At Shock Tower
Fig. 3 Correctly Isolated Remote Ground Cable
This will allow the airbag system capacitor to
de-energize.
(3) Before beginning removal of steering column
assembly from vehicle, be sure front wheels of vehicle
are in the straight ahead position.
(4) Remove fuse panel cover from left end of
instrument panel (Fig. 4). Then remove the screw
behind fuse panel cover, attaching the instrument
panel top cover (Fig. 4).
NOTE: When removing the center bezel, only use a
soft tool such as a trim stick (Fig. 5) to pry the cen-
ter bezel from the dash panel. Use of a hard tool
will damage dash panel.
(5) Remove center bezel surrounding radio and cli-
mate control panel from top cover of dash panel (Fig.
5).
(6) Remove the 3 screws attaching the top cover to
the dash panel (Fig. 6).
(7) Remove the top cover from the dash panel.
Removal of the top cover is required to gain access to
REMOTE GROUND CABLE LEFT GROUNDSTUD AIR CLEANER GROUND TOWER STRUT STUD FUSE CLIMATE CONTROL PANEL COVER PANEL CENTER BEZEL DASH PANEL
Fig. 4 Instrument Panel Top Cover Attaching Screw
Fig. 6 Instrument Panel Top Cover Attaching Screws
the screws (Fig. 7) attaching the top of the knee bol-
ster to the dash panel.
(8) Remove screws attaching the knee bolster to
the instrument panel (Fig. 7).
TRIM STICK RADIO
TOP COVER
SCREWS
STEERING
Fig. 5 Center Bezel
TOP SCREW COVER
19 - 47