Chrysler 1997 Stratus Convertible RHD Service Manual page 964

TILT LEVER WIRING HARNESS CON- CLOCKSPRING CLOCKSPRING NECTORS
19 - 50 STEERING
REMOVAL AND INSTALLATION (Continued)
Fig. 15 Steering Column Shroud Attaching Screws
Fig. 16 Wiring Harness Connection To Clock Spring
And Halo Light
(23) Remove the multi and 2 wire wiring harness
connectors from the back of the ignition switch (Fig.
17). Then remove the 2 wiring harness connector
from the multi function switch (Fig. 17) and (Fig. 18).
(24) Depress the locking tab on the shifter/ignition
interlock cable (Fig. 19) and remove the cable from
the key lock housing.
(25) Remove routing clip holding wiring harness to
jacket of steering column.
(26) Remove retaining pin in steering column cou-
pler pinch bolt (Fig. 20). Loosen the upper to lower
steering coupler pinch bolt retaining nut and remove
pinch bolt from steering coupler (Fig. 20). Pinch
bolt nut is caged to coupler and is not remov-
able. Then separate steering coupler from steering
gear.
ATTACHINGSCREWS STEERING WIRING HARNESS CONNEC- TOR HALO LIGHT SHROUDS COLUMN KEY MULTI-FUNCTION HOUSING IGNITION SWITCH LOCK SWITCH
Fig. 17 Wiring Harness Connections To Ignition And
Fig. 18 Wiring Harness Connection To Multi-
Fig. 19 Shifter/Ignition Cable At Lock Cylinder
MULTI-FUNCTION SWITCH WIRING HARNESS MULTI-FUNCTION SWITCH WIRING HAR- MULTI-FUNCTION SWITCH
SHIFTER IGNITION INTERLOCK CABLE
Multi-Function Switch
Function Switch
Housing
NESS CONNECTOR LOCKING TAB CONNECTOR KEY CYL- INDER
JX