Chrysler 1997 Stratus Convertible RHD Service Manual page 768

9 - 32 2.4L ENGINE
REMOVAL AND INSTALLATION (Continued)
VIBRATION DAMPER
REMOVAL
Remove crankshaft vibration damper bolt. Remove
damper by using Special Tool 1026 and Insert
6827–A (Fig. 49).
Fig. 49 Crankshaft Vibration Damper—Removal
INSTALLATION
Install crankshaft vibration damper using M12 WASHER BEARING M12–1.75 FROM AND 150 MM BOLT, TOOL 6792 SPECIAL THRUST
1.75 x 150 mm bolt, washer, thrust bearing and nut
from Special Tool 6792. Install crankshaft vibration
damper bolt and tighten to 142 N·m (105 ft. lbs.)
(Fig. 50).
Fig. 50 Crankshaft Vibration Damper—Installation
TIMING BELT COVER
FRONT COVER
REMOVAL
(1) Remove crankshaft damper. Refer to crank-
shaft damper removal for procedure.
(2) Remove front timing belt cover fasteners (Fig.
51) and remove cover.
(3) Remove engine mount bracket (Fig. 51).
Fig. 51 Front Timing Belt Covers
INSTALLATION
(1) Install the engine mount bracket and front
timing belt cover (Fig. 51).
(2) Install crankshaft damper. Refer to crankshaft
damper installation for procedure.
REAR COVER
REMOVAL
(1) Remove Front Cover. Refer to Front Cover
Removal procedure outlined in this section.
(2) Remove Timing Belt. Refer to procedure out-
lined in this section.
(3) Remove idler pulleys (Fig. 52).
(4) Remove both camshaft sprockets.
(5) Remove rear timing belt fasteners and remove
cover from engine (Fig. 52).
INSTALLATION
(1) Install rear timing belt cover and fasteners
(Fig. 52).
(2) Install idler (Fig. 52).
(3) Install camshaft sprockets.
(4) Install Timing Belt. Refer to procedure outlined
in this section.
(5) Install front cover. Refer to Front Cover instal-
lation procedure outlined in this section.
JX