Chrysler 1997 Stratus Convertible RHD Service Manual page 847

ENERGY REAR BUMPER FASCIA MANAGEMENT FOAM
JX
REMOVAL AND INSTALLATION (Continued)
(7) Install push-in fasteners holding rear fascia to
rear bumper reinforcement.
(8) Install nuts holding rear fascia to inner quarter
panel.
(9) Install screws holding rear fascia to closure
panel.
(10) Install trunk lining.
Fig. 5 Rear Bumper Energy Management Foam
REAR BUMPER REINFORCEMENT
REMOVAL
(1) Remove rear fascia.
BUMPERS AND FRAME
(2) Support bumper reinforcement on a suitable
lifting device.
(3) Mark position of nuts on frame rail to aid in
installation.
(4) Remove nuts holding rear bumper reinforce-
ment to frame rail (Fig. 6).
(5) Separate bumper reinforcement from vehicle.
Fig. 6 Rear Bumper Reinforcement
INSTALLATION
(1) Position rear bumper reinforcement on vehicle.
(2) Install nuts holding bumper reinforcement to
frame rail. Use previously made marks to properly
position bumper reinforcement.
(3) Install rear fascia.
13 - 3