Chrysler 1997 Stratus Convertible RHD Service Manual page 1194

EGR VALVE SCREW (2) ATTACHING THERMOSTAT SCREWS HOUSING
25 - 28 EMISSION CONTROL SYSTEMS
REMOVAL AND INSTALLATION (Continued)
REMOVAL
(1) Disconnect vacuum supply from solenoid.
(2) Disconnect electrical connector from solenoid.
(3) Remove screws holding transducer to bracket.
(4) Remove screws holding Transmission Control
Module (TCM) to bracket (Fig. 8). Swing TCM up to
allow access to EGR screws (Fig. 9).
Fig. 8 TCM Removal
Fig. 9 EGR Removal
TRANSMISSION MODULE (TCM) CONTROL EGR VALVE EGR TUBE
EGR TUBE
(5) Remove screws holding EGR tube.
(6) Remove EGR valve mounting screws. Remove
EGR valve and transducer.
(7) Clean gasket surfaces. Discard old gaskets. If
necessary, clean EGR passages.
INSTALLATION
(1) Loosely install EGR valve with new gaskets.
(2) Finger tighten EGR tube fasteners.
(3) Tighten EGR tube fasteners to 11 N·m (95 in.
lbs.) torque.
(4) Tightening EGR valve mounting screws to 22
N·m (200 in. lbs.) torque.
(5) Install transducer to bracket.
(6) Connect vacuum supply to solenoid.
(7) Attach electrical connector to solenoid.
EGR TUBE—2.0L
The EGR tube attaches to the intake manifold ple-
num below the throttle body and EGR valve.
REMOVAL
(1) Remove screws attaching EGR tube to intake
manifold (Fig. 10).
(2) Remove EGR tube to EGR valve screws.
(3) Remove EGR tube. Clean gasket surface on the
EGR valve. Wipe clean the grommet on the intake
manifold.
INSTALLATION
The rubber grommet that seals the EGR tube to
intake manifold connection is reusable.
(1) Loosely install the EGR tube and fasteners.
(2) Tighten the EGR tube to intake manifold ple-
num screws to 11 N·m (95 in. lbs) torque.
(3) Tighten the EGR tube to EGR valve screws to
11 N·m (95 in. lbs.) torque.
Fig. 10 EGR Tube Stud Bolts
MOUNTING EGR SCREWS TUBE
JX