Chrysler 1997 Stratus Convertible RHD Service Manual page 908

14 - 54 FUEL SYSTEM
REMOVAL AND INSTALLATION (Continued)
Fig. 80 Upstream Heated Oxygen Sensor Removal/
Installation
REMOVAL
(1) Raise vehicle.
(2) Disconnect electrical connector from sensor.
(3) Disconnect sensor electrical harness from clips
along body.
(4) Remove sensor using an oxygen sensor crow
foot wrench such as Snap-On tool YA8875 or equiva-
lent (Fig. 81).
INSTALLATION
(1) After removing the sensor, the exhaust mani-
fold threads must be cleaned with an 18 mm X 1.5 +
6E tap. If reusing the original sensor, coat the sensor
threads with an anti-seize compound such as Loctite
771-64 or equivalent. New sensors have compound on
the threads and do not require an additional coating.
Tighten the sensor to 28 N·m (20 ft. lbs.) torque.
(2) Connect sensor electrical harness to clips along
body.
(3) Connect electrical connector to sensor.
(4) Lower vehicle.
AIR INLET RESONATOR
2.0L
REMOVAL
(1) Remove 2 bolts holding air inlet resonator to
intake manifold (Fig. 82).
(2) Loosen screw holding resonator to throttle body
(Fig. 83).
(3) Loosen clamp holding resonator to air inlet
tube. Remove resonator.
INSTALLATION
(1) Install air inlet resonator to throttle body.
(2) Install air inlet tube to resonator.
HEATED DOWNSTREAM MOUNTING BOLTS SENSOR OXYGEN
Fig. 81 Downstream Heated Oxygen Sensor
Removal/Installation
Fig. 82 Air Inlet Resonator
Fig. 83 Air Inlet Resonator Attachment to Throttle
(3) Tighten clamps to 3 .5 N·m (25 5 in. lbs.)
torque.
CATALYTIC AIR INLET RES- CONVERTOR
Body
ONATOR
JX