Chrysler 1997 Stratus Convertible RHD Service Manual page 1091

FRONT TO CENTER RAIL ADJUSTING SCREW CENTER RAIL FRONT RAIL
JX
ADJUSTMENTS (Continued)
FRONT TO CENTER RAIL ADJUSTMENT
To align the roof rail weatherstrips to the door and
quarter glass contact, adjust the front to center rail
adjusting screw (Fig. 9). To decrease pressure on door
glass turn adjuster inward. To increase pressure on
door glass turn adjuster outward.
Fig. 9 Roof Rail Adjustment
TOP FRAME CAM ADJUSTMENT
The top frame cam changes forward or rearward
position of the top header in relation to the wind-
shield header. The cam turns inside the rear side rail
and thrust link (Fig. 10). It may be necessary to
lengthen the balance links 1 or 2 serrations after a
cam adjustment. The position of the cam high side
determines the angle between the center and rear
side rails. When the high side is fully forward, the
angle is at a minimum, and when turned rearward,
the angle is increased. An increased angle increases
the forward movement of the top. The cam high side
is indicated by a arrow on the cam threaded end.
TO ADJUST CAM SETTING
(1) Lower top to half down position to remove all
possible strain from the cam.
(2) Remove torx head screw.
(3) Using appropriate torx bit, rotate cam as nec-
essary and secure set screw.
BALANCE LINK ADJUSTMENT
WARNING: DO NOT PLACE HANDS OVER GAPS IN
MOVABLE CONVERTIBLE TOP COMPONENTS DUR-
ING SERVICING. PERSONAL INJURY CAN RESULT.
SERRATED PLATE BALANCE LINK
Fig. 10 Cam Assembly
(1) Remove convertible top head lining as neces-
sary to gain access to adjusters.
(2) With the top latched in up position, loosen both
bolts just enough to permit moving link up or down
(Fig. 11).
(3) Push upward in the area of the front to center
rail joint. Push rails up by hand as far as possible.
(4) With the balance link adjusting bolts loosened,
allow the balance link to seek proper position
(5) Tighten bolts while rail is held in position.
Fig. 11 Balance Link Adjustment
BODY 23 - 21