Chrysler 1997 Stratus Convertible RHD Service Manual page 870

14 - 16 FUEL SYSTEM
OPENING IN MODULE
REMOVAL AND INSTALLATION (Continued)
(3) Insert a screwdriver between the fuel pump
module and the top of the level sensor housing (Fig.
23). Push level sensor down slightly.
Fig. 23 Loosening Level Sensor
(4) Slide level sensor wires through opening fuel
pump module (Fig. 24).
Fig. 24 Level Sensor Removal/Installation
(5) Slide level sensor out of channel in module.
INSTALLATION
(1) Insert level sensor wires into bottom of opening
in module.
(2) Wrap wires into groove in back of level sensor
(Fig. 25).
(3) While feeding wires into guide grooves, slide
level sensor up into channel until it snaps into place
(Fig. 26). Ensure tab at bottom of sensor locks in
place.
(4) Install level sensor wires in connector. Push
the wires up through the connector and then pull
them down until they lock in place. Ensure signal
and ground wires are installed in the correct position
(Fig. 27).
FUEL LEVEL SENSOR
Fig. 25 Groove in Back Side of Level Sensor
(5) Install locking wedge on connector.
(6) Push connector up into bottom of fuel pump
module electrical connector.
WRAP PUMP MODULE WIRES GROOVE IN
Fig. 26 Installation Channel
Fig. 27 Fuel/Pump/Level Sensor Electrical
Connector
CHANNEL LEVEL SENSOR OF REAR VIEW SENSOR LEVEL FOR
JX