Chrysler 1997 Stratus Convertible RHD Service Manual page 871

JX
IGNITION COIL
FUEL SUP-
PLY LINE
REMOVAL AND INSTALLATION (Continued)
(7) Install fuel pump module. Refer to Fuel Pump
Module in this section.
FUEL RAIL—2.4L
REMOVAL
(1) Disconnect negative
jumper terminal.
WARNING: RELEASE FUEL SYSTEM PRESSURE
BEFORE SERVICING FUEL SYSTEM COMPONENTS.
SERVICE VEHICLES IN WELL VENTILATED AREAS
AND AVOID IGNITION SOURCES. NEVER SMOKE
WHILE SERVICING THE VEHICLE.
(2) Release fuel system pressure. Refer to Fuel
System Pressure Release procedure in this section.
WARNING: WRAP SHOP TOWELS AROUND HOSE
TO CATCH ANY GASOLINE SPILLAGE.
(3) Disconnect fuel supply tube from rail. Refer to
Quick-Connect Fittings in the Fuel Delivery section
of this group.
(4) Disconnect electrical connectors from fuel injec-
tors (Fig. 28).
Fig. 28 Fuel Rail and Injectors
(5) Remove fuel rail mounting screws.
(6) Lift rail off of intake manifold. Cover the fuel
injector openings in the intake manifold.
INSTALLATION
(1) Apply a light coating of clean engine oil to the
O-ring on the nozzle end of each injector.
(2) Insert fuel injector nozzles into openings in
intake manifold. Seat the injectors in place. Tighten
fuel rail mounting screws to 22.5 N·m
(200 30 in. lbs.).
(3) Attach electrical connectors to fuel injectors.
FUEL RAIL QUICK- FUEL CONNECTS LINE
FUEL INJEC-
TOR
cable from auxiliary
SUPPORT BRACKET BOLT
(4) Connect fuel supply tube to fuel rail. Refer to
Quick Connect Fittings in the Fuel Delivery Section
of this Group.
(5) Connect negative cable to auxiliary jumper ter-
minal.
FUEL RAIL—2.5L
REMOVAL
(1) Disconnect
jumper terminal.
WARNING:
BEFORE SERVICING FUEL SYSTEM COMPONENTS.
SERVICE VEHICLES IN WELL VENTILATED AREAS
AND AVOID IGNITION SOURCES. NEVER SMOKE
WHILE SERVICING THE VEHICLE.
(2) Release fuel system pressure. Refer to Fuel
System Pressure Release procedure in this section.
WARNING: WRAP SHOP TOWELS AROUND HOSE
TO CATCH ANY GASOLINE SPILLAGE.
(3) Disconnect fuel supply tube from rail. Refer to
Quick-Connect Fittings in the Fuel Delivery section
of this group.
(4) Unplug connectors from MAP and intake air
temperature sensors (Fig. 29).
Fig. 29 Intake Manifold Plenum Sensors and Left
(5) Remove plenum support bracket bolt located
rearward of MAP sensor (Fig. 29).
(6) Remove bolt holding air inlet resonator to
intake plenum.
(7) Loosen throttle body air inlet hose clamp.
3 N·m
(8) Release snaps holding air cleaner housing
cover to housing.
(9) Remove air cleaner cover and inlet hoses from
engine.
FUEL SYSTEM
MAP SENSOR
negative cable
RELEASE FUEL SYSTEM PRESSURE
Plenum Support Bolt
14 - 17
PERATURE INTAKE AIR TEM- SEN- SOR
from auxiliary