Chrysler 1997 Stratus Convertible RHD Service Manual page 1103

BELL-CRANK WATERSHIELD DOOR LOCK LINKAGE LOCK BUTTON
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 24 Door Watershield
LOCK BUTTON BELL-CRANK
REMOVAL
(1) Remove door trim panel.
(2) Disengage clip holding lock linkage to bell-
crank.
(3) Rotate bell-crank until retaining ears align
with slots in door panel.
(4) Separate bell-crank from door (Fig. 25).
Fig. 25 Lock Button Bell-Crank—Typical
INSTALLATION
Reverse the preceding operation.
SIDE VIEW MIRROR
REMOVAL
(1) Remove side view mirror cover (Fig. 26).
(2) If vehicle is equipped with power mirrors,
remove the door trim panel.
(3) Disengage power window mirror motor wire
connector, if so equipped.
LATCH LINKAGE MIRROR SIDE VIEW MIRROR COVER SIDE VIEW MIRROR WIRE CONNECTOR
(4) Disengage wire harness grommet from mirror
flag, if so equipped.
(5) Remove nuts holding side view mirror to mir-
ror flag (Fig. 27).
(6) Separate side view mirror from vehicle.
INSTALLATION
(1) Feed power mirror wire harness through hole
in mirror flag and seat grommet. Do not pull on wire
harness to seat grommet.
(2) Position side view mirror to vehicle.
(3) Install nuts holding side view mirror to mirror
flag.
(4) Engage push–in fastener holding power mirror
wire connector to inner door panel, if so equipped.
(5) Engage power mirror motor wire connector, if
so equipped.
(6) Install side view mirror cover.
MIRROR FLAG FLAG/GLASS CHANNEL
Fig. 26 Side View Mirror Cover
Fig. 27 Side View Mirror
BODY 23 - 33